VIS-A-VIS LiveCare Link+ User manual

LiveCare Link+
User Guide
Vis-À-Vis Health
www.visavishealth.com

Link+
User Guide

Setup the Link+
Step 1: Set Up the Charging Dock
To set up your charging dock, connect the charging
cable and adapter to a power or wall outlet.
1
Charging Dock Charging Adapter

Step 2: Power On Link+
Next, plug the Link+ into the charging dock. The
Link+ will automatically power on, and the LiveCare
logo will appear on the screen. (This process could
take up to 2 minutes.)
Note: Always leave the Link+ on the charging dock.
2

Step 3: Accept Terms and Conditions
Once the Link+ powers on, please accept LiveCare
Terms and Conditions and RPM Consent Form.
3

Step 4: Your Link+ is Ready!
Your Link+ is set up and ready to
take your vital signs.
4

How to Take Blood Pressure
Step 1: Connect Blood Pressure Cuff
Insert the connector with cuff tube into the air socket
located on the left side of the blood pressure monitor.
(See picture)
Step 2: Wrap cuff around your arm
Rest your left arm flat on the table or arm of a chair.
Make sure cuff is heart level with your heart.
Step 3: Press the “Start” button
Press the “Start” button, and the Blood Pressure Monitor will
begin to take your blood pressure. Once it has finished, it will
automatically send your information via the Link+.
123

How to Take Pulse
Step 1: Press the “Start” button
Place the Pulse Oximeter on the finger. (See Proper Usage
Recommendations)
Press the “Start” button, and the Pulse Oximeter will begin to
take your pulse. Once it has finished, it will automatically send
your information via the Link+.
Step 2: Remove Pulse Oximeter from finger
Once complete, remove Pulse Oximeter from your finger. The
Pulse Oximeter will automatically power off after 5 seconds,
Power/Start
Button
Battery
Indicator
Pulse Rate
Oxygen
Saturation

Emergency Response Feature
Step 1: Press red emergency button
On the Link+ device, press the red emergency
button and hold for 2 seconds to call for help.
1

Step 2: Confirmation screen
After holding down the emergency button you
will see a confirmation screen asking if you have
an emergency. If the request did not go through,
you will see a screen prompting you to call 911.
2

Proper Usage Recommendations
Proper usage of your Blood Pressure Monitor and Pulse
Oximeter is very important for taking accurate vitals
Blood Pressure Monitor
Don’t eat or drink anything in the half hour before
you take your blood pressure.
Sit in a confortable chair with your back supported
for at least 5 minutes before your reading.
Make sure the Blood Pressure Cuff is snug but not
too tight. The cuff should be against your bare skin,
or over thin clothing.
Pluse Oximeter
Try not to move when taking pulse oxygen to prevent
abnormal readings.
Place Pulse Oximeter on middle finger or ring finger
for the most accurate reading.
Make sure hands are not too hot or cold before taking
reading.
!

Phone: [phone]
Email: [email protected]
Website: www.visavishealth.com