
4. Hold both leg sections in the middle with one hand and align the center
hole where the concave sections are. With the other hand, fasten one
short hand knob screw (G) making sure the washer (I) goes on first so it’s
resting in the screw hole pocket.
5. Position the seat to the edge of the table or bed so you can install the seat
legs easily.
6. Align one L-Shape back seat frame (C) to the two left screw holes on the
seat. Fasten together using 2 washers (I) and 2 long hand knob screws (H).
7. Repeat step 7 for the right side L-Shape back seat frame.
8. Attach the back support (A) to both L-Shape frames and fasten with 4
washers (I) and 4 short hand knob screws (G).
9. Attach each armrest (E1 & E2) to each side
where you see the round metal sleeves
on the frame legs. The armrests should
be at an angle pointing away from the
chair. Make sure to hear an audible snap
when securing the armrests. See Fig. 2.
WARNING
• Check periodically to make sure all fixings are tight and secure.
Fig. 2
F
E2
E1