Vivitek DT01 User instructions

Setting Up DT01/DT02 with Finger Touch
1.Download the correct D-point driver from Vivitek.eu
http://www.vivitek.eu/products/education-projectors/
These models use the following D-point version
D755WTI (not compatible with laser module)
- D-point software version 1.1.1.3 for Windows
- D-point software version 1.1.1.4 for Mac
D755WTIR
- D-point software version 2.2.3.0.16 for Windows
- D-point software version 2.2.1.3 for Mac
D758USTIR
- D-point software version 2.2.3.0.16 for Windows
- D-point software version 2.2.1.3 for Mac
Follow the steps when installing the software.

2. Connect projector to PC
Connect the Mini USB cable to the projector and your
computer.
When you connect the USB for the first time Windows will
install the driver.
Please wait until windows is finished, after installation is
completed you will get an notification that the projector is
connected.

3. Open the D-point software and select the correct
settings
Select pen mode and click configuration.
(Pen mode is used for calibration even if you want to use
Finger mode)
Select all the correct settings and press next

4. Calibration
After Auto calibration is finished press the Finish button.
With the interactive Pen you can check if the interactivity works.

5. Connect the USB cable of the laser module.
Use the D-point alignment view to adjust the laser module.
More details about alignment view can be read from the
user manual.
User manual can be found on the green CD or
downloaded from www.vivitek.eu.

6. Change the settings in D-point software from Pen
mode to Finger mode.
The setup is now complete.
If the Finger mode is not accurate then go back to step 3
and select Manual calibration.