2 3
ASSEMBLY STEPS
STEP 1
STEP 3
STEP 2
STEP 4
STEP 5
C
E
F
C
I
B
G
H
Right
Left
A
Desktop
D
Assemble the Keyboard Tray (E) using Connecting Plates (F) and M5x12 Flat Head Screws (C), and
tighten with a Phillips screwdriver.
Assemble Slider Brackets (G) to the Keyboard Tray (E) using M5x12 Screws (B), and tighten with a
Phillips screwdriver. The slider brackets should protrude from the back of the keyboard tray.
NOTE: If the keyboard tray is not sliding in completely , remove the keyboard backstop on the
tray. This will allow for an extra 0.75” (19mm) of clearance. If more clearance is needed, change the
orientation of the desk having the sync rod facing towards you. This will avoid the crossbar and cable
tray entirely.
Attach the Keyboard Stop (I) to the back of the Keyboard Tray (E) using M5x12 Flat Head Screws (C).
Tighten with a Phillips screwdriver.
Assemble Clamps (H) to the Slider Brackets (G) using M4x7 Screws (A). Tighten with a Phillips
screwdriver.
NOTE: Clamp can be oset using the extra holes in Slider Brackets (B) to allow the tray to be pulled
out an extra 1.2” (30mm) when in use. If mounted this way the tray will sit further out from desk edge.
Place Pads (D) on the underside of each clamp. Place assembled keyboard mount on the edge of the
desk and tighten clamps.
NOTE: To ensure keyboard tray is level, do not over-tighten clamps.
Slide keyboard tray forward/back to the desired position.
PACKAGE CONTENTS
TOOLS NEEDED
11lbs
(4.99kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
Phillips
Screwdriver
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or
injury caused by improper mounting, incorrect assembly or inappropriate use.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
A(x6)
M4x7
B(x8)
M5x12
D(x2)
Pad
F (x2)
Connecting
Plate
C(x12)
M5x12 Flat Head
E(x1)
Keyboard
Tray
G(x2)
Sliding Bracket
H(x2)
Clamp
I(x1)
Keyboard Stop
NOTE: 2 Extra screws have been included of each
