volkano Vinyl Series User manual

1. Adjusting the Volume
Function Operation
Increase/decrease
Volume
Rotate the “volume control”
• Clockwise to increase the volume
• Counter clockwise to decrease the volume
2. Audio Control
Function Operation
Bluetooth, USB & Micro SD Modes
Navigate to Next Track Short press the “Next” button
Navigate to Previous Track Short press the “Previous” button
Play or Pause Track Short press the “Play/Pause” button
Phonograph Mode
Turn Auto Stop On/Off Flick the “Auto Stop Switch” to the respective position
To set the Play Back Speed Flick the “Speed Switch” to the respective position
Playing A Phonograph Record
1. Lightly place the record that you wish to play on the turn
table plate.
2. Unclip the Tone arm protector and push the lift leaver back.
3. Slide the tone arm over the record, at this point the recode
will start spinning. Pull the Lift leaver forward. The tone arm
will slowly lower itself until it rests on the record and the
Retro will start playing the record.
Stop Playing a Phonograph
Record
1. Push the lift leaver back.
2. Slide the Tone arm to above the safety clip.
3. Pull the leaver forward and allow the tone are to rest on
the holder.
4. Clip the Tone arm protector into place.
5. Remove the record from the turn table.
3. FM Controls
Function Operation
Navigate to Next Station Short press the “/Next” Button
Navigate to Previous Station Short press the “/Previous” Button
Auto Search for FM Stations Press and hold the “Play/Pause” Button