Vollrath E-Z Guide

E-Z Juice Extractor Care and Use
To ensure safe installation and operation, read the following
statements and understand their meaning. Please read carefully.
ASSEMBLY AND OPERATION
1. Slide the strainer (1) into the funnel (2) rotating to align the
keyway if necessary. See Figure 1.
2. Set the strainer (1) and the funnel (2) into the funnel holder
(3). The handle (4) may need to be rotated to do this.
3. Place a vessel between the legs of the base (6) under the
funnel (2) to catch the extracted juice.
4. The juice extractor is now ready for use. See Figure 2.
5. Place 1/2 citrus or other food product between the pressure
cup and the strainer and press the juice out by turning the
handle. Reverse the handle and remove fruit or food
product. Continue this procedure as needed.
Figure 1. Juice Extractor Components and Parts Figure 2. Juice Extractor Assembled (Show with
Vessel)

CLEANING PROCEDURES
1. Clean juice extractor immediately after use.
2. Disassemble the juice by reversing the assembly instructions listed earlier.
3. The strainer (1) and funnel may be cleaned in a dishwasher or in hot soapy water. Dry immediately
after washing.
4. Wipe the base (6), pressure cup (7), handle (4), and the other parts should be wiped with a clean
soapy towel, wiped again with a clean damp towel and dried immediately.
SPARE PARTS LIST - JUICE EXTRACTOR 47704 (SEE FIGURE 1)
Callout
Part No.
Description
1
45626-1
Strainer
2
45627-2
Funnel
3
45625-1
Funnel Holder
4
45756-2
Handle Assembly
5
N/A
Screw, Slotted, 1/4-20 x 5/16"
6
21910-1
Base Assembly
7
45628
Pressure Cup
8
21939-1
Pinion Gear
9
45629-1
Housing Assembly
10
21941-1
Rack Assembly
Not Shown
45618
Parts Bag (screws, washers, ring, pinion, rubber feet, spring)
http://vollrathuniversity.com/vollrathUniversity/Product-Training/Food-Prep-Equipment/E-Z-Juice-
Extractor-Care-and-Use.htm