VPNet VSU 100 User manual

VSU Quick Start
NOS version 3.1
Preconfigure your VSU to enable remote
communications with the VPNmanager.
1. Connect the VSU console cable (provided) to the
serial port of a PC running Hyperterminal or a
dumb terminal. Press return.
2. From the VSU consoles Main Menu select Quick
Setup and press return.
3. Enter the public IP address and netmask assigned
to VSU. If a secondary IP address is to be used,
answer “y” to the prompt and enter secondary IP
address and mask.
Refer to the VPNmanager Administrator’s Guide
Chapter 4 for more information
Refer to the VPNmanager Administrator’s Guide
Chapter 4 for more information
5. Select the desired filtering operation. Refer to
Chapter 3 in the VSU User Guide for details.
6. Change the console password.
4. Enter the default route.

VSU Quick Start
NOS version 3.1
7. Enter your new superuser name.
8. If FIPS mode is required, select “y”, otherwise
choose “n”. (See Chapter 3 of the VSU User Guide
for more information)
9. Enter the time and date.
NOTE: By default, the VSU acts
as a bridge for non-VPN traffic.
See section on Filtering in
Chapter 3 of the VSU User
Guide
.
Refer to the VPNmanager
Administrator’s Guide,
Chapter 4 for more
information.
11.Deploy the VSU to it’s final position in the network.
10.Reboot the VSU.
© 2001 by VPNet Technologies Inc.
P/N 09-0051-02