Vremi VRM010679N User manual

Electric Blanket | 1
This Is
A Manual.
You're Getting Warmer Electric Blanket

Electric Blanket | 4
Important Safety Instructions
DANGER: To reduce risks of burns, electric
shock, fire, and personal injury, this product
must be used in accordance with the
following instructions:
Setting Up:
1. NEVER trap or pinch any of the electrical cords in any way. Make
sure the cords are NEVER rested between the mattress and box
springs.
2. The heated area should always lie flat to prevent overheating.
3. If the plug does not fit into your outlet, contact a qualified
electrician.
4. Be sure that the power supply is used only on 120V, 60 HZ
current supply.
5. Make sure the cord from the controller to your heated product is
connected and locked tightly.
6. You may use this electric product with any sheets, mattress pads or other blankets but NEVER
in combination with any other electric blankets or electric mattress pads.
7. The warming product should never be folded, balled up or bunched in any way when in use.
May result in overheating and/or permanent wrinkling of the fabric.
8. Do not use with generators, power converters, or inverters.
Care and Maintenance:
1. NEVER use pins in and around the warming product.
2. Cats, dogs and other pets should always be kept away from the product, as a sharp claw may
result in damage to the heating element.
3. Always turn off the electric current when the warming product is not in use, either by turning
off the controller or unplugging from the wall outlet.
4. Wrapping of the cord around the controls may damage the cord. Loop loosely when storing.
5. NEVER iron your warming product.
6. NEVER use dry cleaning fluid on this product. Cleaning solvents may damage the wiring insulation.
7. Do not tuck in the wired area of this bedding.
8. Do not route electrical cords between the mattress and box spring.
9. Do not allow the cords to be pinched.
10. Keep the control away from drafty areas that may become damp or wet such as an open window.
11. Do not use pins – They may damage the electric wiring.
12. Be sure that this bedding is used on an alternating-current supply circuit of the proper voltage.
13. Turn off or unplug when not in use. Excessive heating may result from folding bedding, other
than a mattress, when in actual use.
14. If improper operation of this bedding is observed, discontinue its use immediately and
consult the manufacturer or the dealer regarding its repair.

Electric Blanket | 5
15. For throw blankets only: Do not use with rocking chairs, recliners, chairs with casters or wheels,
or other furniture subject to movement.
16. Do not tuck the blanket or supply cord in a sofa or other furniture. All portions of the blanket
or controller should be visible at all times.
This Electric Blanket has a polarized plug (one blade is wider than the other) as a safety feature.
This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician.
DO NOT ATTEMPT TO DEFEAT THIS SAFETY FEATURE.
SAVE THESE INSTRUCTIONS
For Household Use Only

Electric Blanket | 6
Parts List
1. Electric Blanket
2. Blanket Connector
3. Control Connector
4. Control Panel
5. Power Cord
2
4
5
3
1

Electric Blanket | 7
Operating Instructions
Before each use, always inspect the product to ensure there is no damage
to the Power Cord, the Control Panel and the Blanket.
WARNING:
1. The Blanket Connector and Control Connector are designed
to connect only one way. Align the inner prongs and then push
together until Connectors are fully inserted (Fig. 1).
2. Plug the product into a 120V AC electrical outlet.
NOTE: If there is no power, make sure the AC electrical outlet is functional and the connection in
step 1 is secure. Discontinue use if failure continues.
3. Use the Control Panel to set the heat to desired level.
NOTE: Heat levels are “85” (low), “85-110” and “110” (high).
4. Press the On/Off Button on the Control Panel. The display will illuminate and all icons will
display. As a default, “85°F” will display, indicating the Control is set at the lowest heat
level. “4h” will display, indicating the Control Panel is set at the 4 hours auto off.
WARNING: Burns may occur even if you set the temperature at low level. Check your skin
under the Blanket frequently.
5. To change your desired heat level, press the “+” Button for a higher heat level or the “-”
Button for a lower heat level. You can set it within 3 seconds after turning on and “SET“ will
appear for about 3 seconds, and then display the real-time temperature of the pad.
Display Of Heat Level Settings:
as Level 6
as Level 3
NOTE: If the Control Panel shuts off, make sure the Blanket and Control connectors are
securely connected and re-start the product by pressing the On/Off Button.
6. Place the Blanket on top of the body. If the Blanket does not heat evenly, make sure there
are no folded areas.
7. Turn the product off by pressing the On/Off Button. Unplug it when not in use.

Electric Blanket | 8
Operating Instructions
Auto Off Function:
This product will turn off after a set duration of time. You can set it at 0.5 hour (30 minutes),
1.0 hour, 1.5 hours (90 minutes), 2.0 hours (120 minutes), 2.5 hours (150 minutes), 3.0 hours
(180 minutes), 3.5 hours (210 minutes) and 4.0 hours (240 minutes).
1. After turning the Blanket on and selecting the desired heat setting, press the “ ” Button
until the desired amount of time is displayed. Time display will flash for 3 seconds, and then
the desired time setting will display steadily.
NOTE: When the Electric Blanket is turned off, the default Auto Off is 4.0 hours (240min).
2. Repeat the above step to change the Auto Off setting.
WARNING: THE CONTROL CONNECTOR CANNOT BE COVERED WHEN USING.
Troubleshooting
Product will not turn on. Make sure that the Plug is plugged securely into
a 120V/60Hz outlet.
Make sure that the Connectors are connected and
fully inserted.
Possible Causes & Solutions
Problem

Electric Blanket | 9
WASHING INSTRUCTIONS
WARNING: NEVER DRY CLEAN OR USE BLEACH.
BEFORE WASHING, DISCONNECT ALL CORDS.
Machine Wash:
NEVER submerge cords or control unit. Place textile portion without cords
in the washing machine. Machine wash warm on gentle or delicate cycle.
Hand Wash:
Washing your warming product by hand is the best way to make it last. To do this,
disconnect all cord(s). Wash your textile separately by hand in a tub of lukewarm (100°F)
water using a small amount of mild laundry soap or detergent. Soak for 5 minutes. Next,
gently work the textile up and down for five more minutes. NEVER rub or scrub. Rinse
thoroughly in cool water until all traces of soap or detergent are gone. Squeeze excess
water out by hand, NEVER twist.
Do not use a wringer.
DRYING INSTRUCTIONS
WARNING: NEVER USE COMMERCIAL DRYERS AT THE LAUNDROMAT. THEY MAY BE
EXTRA HOT AND COULD DAMAGE THE WIRING. DO NOT IRON. DO NOT PLUG IN UNTIL
COMPLETELY DRY.
Machine Dry:
To machine dry, put your product into a dryer on low heat and allow to tumble until dry. Ensure
that the textile has enough room to tumble freely. If product draws in during washing, while
still damp gently stretch until it returns to its original size.
Line Dry:
You can line dry, simply by draping over two parallel clotheslines or a shower rod with the
head and foot ends down. Do not reconnect warming products until they are completely dry.
Do not use clothes pins that can pinch wires.
Storage:
Store as you would any other bedding, folded in a dry place.
Cleaning & Maintenance

Electric Blanket | 10
FREQUENTLY ASKED QUESTIONS
1. When should an Electric Blanket be used?
Whenever a hot form of temporary relief is desired for personal comfort.
2. What temperature does this product reach?
Maximum temperature should not exceed the laboratory test limit of 149°F
when set to Level 6. Temperature varies by heat setting. You may need to use a lower
heat setting depending on the specific application and your personal preference.
3. How much time does it take to heat up to each temperature selection?
Temperature Selection Indicator Heat Up Elapsed Time
Low 85°F 15 min
2 90°F 20min
3 95°F 30 min
4 100°F 40 min
5 105°F 50 min
High 110°F 60 min
Cleaning & Maintenance

Electric Blanket | 11
This manual is to be used with all items with the model numbers
RATING: 120VAC, 60 Hz, 115 W, 0.96A, AC ONLY
Keep all plastic bags away from children.
Warranty Information
Vremi offers a 12-month warranty on all of our products purchased new and unused from
Vremi LLC or an authorized reseller, with an original proof of purchase and where a defect has
arisen, wholly or substantially, as a result of faulty manufacturing, parts or workmanship during
the Warranty Period. The warranty does not apply where damage is caused by other factors,
including but without limitation: (a) normal wear and tear; (b) abuse, mishandling, accident or
failure to follow operating instructions; (c) exposure to liquid or infiltration of foreign particles;
(d) servicing or modification of the product other than by Vremi. These are our general terms
for the warranty service, but we always urge our customers to reach out to us with any issue,
regardless of warranty terms. If you experience an issue with a Vremi product, please contact
us at support@vremi. com, and we will do our best to resolve it for you.
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This product may not cause harmful interference and
(2) This product must accept any interference received,
including interference that may cause undesired operations.
vremi. com/chat
CHAT WITH US
(646) - 490 - 9904
CALL US
support@vremi. com
EMAIL US
Drop Us A Line
VRM010679N
Warning

Electric Blanket | 12
vremi. com