VTI Instruments EX1401 User manual

PROPRIETARY NOTICE
THIS DOCUMENT AND THE TECHNICAL DATA DISCLOSED
ARE PROPRIETARY TO VTI INSTRUMENTS CORP. AND
SHALL NOT, WITHOUT EXPRESS WRITTEN PERMISSION OF
VTI INSTRUMENTS CORP., BE USED, RELEASED, OR
DISCLOSED IN WHOLE OR PART OR USED TO SOLICIT
QUOTATIONS FROM A COMPETITIVE SOURCE OR BE USED
FOR MANUFACTURE BY ANYONE OTHER THAN
VTI INSTRUMENTS CORP. THE INFORMATION HERE ON
DISCLOSED HAS BEEN DEVELOPED AT PRIVATE EXPENSE
AND MAY ONLY BE USED FOR PURPOSES OF
ENGINEERING EVALUATION AND FOR INCORPORATION
INTO TECHNICAL DOCUMENTS WHICH SPECIFY
PROCUREMENT FROM VTI INSTRUMENTS CORP.
REVISION HISTORY
REV ECO DESCRIPTION DATE APPROVED
A 11733 Initial Document Release 12May17 PFW
VTI Instruments Corp.
2031 Main Street, Irvine CA 92614 [phone]
MANUAL, QUICKSTART GUIDE, EX1401
ENGR P. Wittibschlager CHECKED F. GenKuong DOC
No. 82-0156-100 REV A
DRAFTED P. Wittibschlager APPROVED F. GenKuong FILE: 82-0156-100-
A
.doc
CAGE 03LB1 SIZE
A
Page 1 of 2
Table of Contents
1Purpose..............................................................................................................................................................2
2Scope..................................................................................................................................................................2
3Instructions for printing...................................................................................................................................2

MANUAL, QUICKSTART GUIDE,
EX1401 DOC
No. 82-0156-100 REV. A Page 2 of 2
1Purpose
This document provides instructions on how to produce (print) the EX1401 Quick Start Guide.
2Scope
This document should be used by the printer as a reference guide when printing the EX1401 Quick Start Guide.
3Instructions for printing
3.1 The source file for the printing is a large bitmap image, filename: 82-0156-100_A.bmp.
3.2 The print is to be done on a single sheet of paper, 8.5” x 11”.
3.3 The print is to be done in “portrait” mode, on both sides, as shown in the picture below.
3.4 The print is to be done in color, matching the bmp image as closely as possible.
3.5 The bitmap image is to be printed “best fit” but do not change the aspect ratio.
3.6 Maintain reasonable margins around the edges.