Waldorf RNL8200G Series User manual

I n s t a l l a t i o n a n d O p e r a t i o n M a n u a l
Gas Cooktops
Series
RN8200G RNL8200G RNB82 00G RNLB8200G
RN84 00G RNL8400G RNB8400G RNLB8400G
RN86 00G RNL8600G RNB8600G RNLB8600G
RN88 00G RNL8800G RNB8800G RNLB8800G
228605-29
For use in GB, IE & DK

The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in
writing by the manufacturer.
In line with policy to continually develop and improve its products, Moffat Ltd. reserves the right to change the specifications and
design without prior notice.
© Copyright Moffat Ltd. May 2017.
Moffat Limited
Rolleston 7675
New Zealand
AUSTRALIA
Moffat Pty Limited
Web: www.moffat.com.au
E.Mail: [e-mail]
Main Office: (tel) [phone]
(fax) [phone]
Service: (tel): 1800 622 216
Spares: (tel): 1800 337 963
Customer Service: (tel): 1800 335 315
(fax): 1800 350 281
CANADA
Serve Canada
Web: www.servecanada.com
E.Mail: [e-mail]
Sales: (tel): 800 551 8795 (Toll Free)
Service: (tel): 800 263 1455 (Toll Free)
NEW ZEALAND
Moffat Limited
Web:www.moffat.co.nz
E.Mail: [e-mail]
Main Office: (tel): 0800 663328
UNITED KINGDOM
Blue Seal
Web: www.blue-seal.co.uk
E.Mail: [e-mail]
Sales: (tel): [phone]
(fax): [phone]
Spares: (tel): [phone]
(fax): [phone]
Service: (tel): [phone]
(fax): [phone]
UNITED STATES
Moffat
Web: www.moffat.com
Sales: (tel): 1-800 551 8795 (Toll Free)
(tel): 336 661 1556
(fax): 336 661 9546
Service: (tel): 866 673 7937 (Toll Free)
REST OF WORLD
Moffat Limited
Web:www.moffat.co.nz
E.Mail: expo[email protected]

Waldorf Gas Cooktops
RN(L)(B)8200G Gas Cooktop 300mm wide.
RN(L)(B)8400G Gas Cooktop 600mm wide.
RN(L)(B)8600G Gas Cooktop 900mm wide.
RN(L)(B)8800G Gas Cooktop 1200mm wide.
Model Numbers Covered in this Specification
General
Gas Supply Requirements
Gas Connection
Installation Requirements
Unpacking
Location
Clearances
Assembly
Fitting Adjustable Feet / Rear Rollers to Leg Stand Units
Fitting Adjustable Feet / Rear Rollers to Cabinet and Refrigeration Bases
Gas Connection
Commissioning
Operation Guide
Description of Controls
Open Burners ('F' - Flame Failure Option)
Open Burners ('PF' - Pilot and Flame Failure Option)
Griddle
Before Commencing Cleaning
Open Burner Cleaning
Griddle Plate Cleaning
Stainless Steel Surfaces
Conversion Procedure
Gas Specifications

2
We are confident that you will be delighted with your WALDORF GAS COOKTOP, and it will become a most
valued appliance in your commercial kitchen.
To ensure you receive the utmost benefit from your new Waldorf Gas Cooktops, there are two important
things you can do.
Please read the instruction book carefully and follow directions given. The time taken will be well spent.
If you are unsure of any aspect of the installation, instructions or performance of your appliance,
contact your WALDORF dealer promptly. In many cases a phone call could answer your question.
These instructions are only valid if the country code appears on the appliance. If the code does not
appear on the appliance, refer to the supplier of this appliance to obtain the technical instructions for
adapting the appliance to the conditions for use in that country.
GREAT CARE MUST BE TAKEN BY THE OPERATOR TO USE THE EQUIPMENT SAFELY TO GUARD IT AGAINST RISK OF
FIRE.
 THE APPLIANCE MUST NOT BE LEFT ON UNATTENDED.
 IT IS RECOMMENDED THAT A REGULAR INSPECTION IS MADE BY A COMPETENT SERVICE PERSON TO
ENSURE CORRECT AND SAFE OPERATION OF YOUR APPLIANCE IS MAINTAINED.
 DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPOURS OR LIQUIDS IN THE VICINITY OF
THIS OR ANY OTHER APPLIANCE.
 DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.
IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE PROPERTY
DAMAGE, INJURY OR DEATH. READ THE INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
THOROUGHLY BEFORE INSTALLING OR SERVICING THIS APPLIANCE.
INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE USER SMELLS GAS ARE TO BE POSTED IN A PROMINENT
LOCATION. THIS INFORMATION SHALL BE OBTAINED BY CONSULTING THE LOCAL GAS SUPPLIER.

3
RN[1]8200G-[2]-[3] 2 Open Burners.
RN[1]8203G -[3] 300mm Griddle.
RN[1]8400G-[2]-[3] 4 Open Burners.
RN[1]8403G-[2]-[3] 2 Open Burners + 300mm Griddle.
RN[1]8406G -[3] 600mm Griddle.
RN[1]8600G-[2]-[3] 6 Open Burners.
RN[1]8603G-[2]-[3] 4 Open Burners + 300mm Griddle.
RN[1]8606G-[2]-[3] 2 Open Burners + 600mm Griddle.
RN[1]8609G -[3] 900mm Griddle.
RN[1]8800G-[2]-[3] 8 Open Burners.
RN[1]8803G-[2]-[3] 6 Open Burners + 300mm Griddle.
RN[1]8806G-[2]-[3] 4 Open Burners + 600mm Griddle.
RN[1]8809G-[2]-[3] 2 Open Burners + 900mm Griddle.
NOTE:
[1]: - Model Options;
- - Standard Models.
L- Low Back Models.
B- Bold Front.
LB - Low Back and Bold Front.
[2] - Open Burner Options;
F- With Flame Failure Protection.
PF - With Pilot and Flame Failure Protection.
[3] - Base Stand Options;
B - Bench Mount.
CB - Cabinet Base (excluding RN8200G Series).
LS - Leg Stand (excluding RN8200G Series).
RB - Refrigerated Base (RN8600G and RN8800G Series only).
A heavy duty, high efficiency Cooktop for modular kitchens. It has a high option Cooktop / Griddle
arrangement and is available either on industrial adjustable feet or on robust rollers. Griddle options
with 4 models of base unit available (except RN8200G model). Fitted with either 'Individual Flame
Failure' (F) or 'Pilot and Flame Failure' (PF) option for each open burner. Griddles are fitted with
pilot, flame failure and piezo ignition as standard. Easy clean stainless steel external finish.

4
- Australia
- New Zealand
- United Kingdom
Category: II2H3P (20, 37).
Flue Type: A1.
* - Measure burner operating pressure at manifold test point with two burners operating at full
setting. Operating pressure is ex-factory set, through appliance regulator and is not to be
adjusted, apart from when converting between gases, if required. (Refer to ‘Gas Conversion’
section for details).
Input Rate (N.H.G.C.)
- each Open Burner
28 MJ/hr 28 MJ/hr
- each 300mm Griddle Section 21 MJ/hr 21 MJ/hr
Supply Pressure 1.13 - 3.40 kPa 2.75 - 4.50 kPa
Burner Operating Pressure (*) 0.95 kPa 2.6 kPa
Gas Connection See ‘Gas Connection’ information overleaf.
Input Rate (N.H.G.C.)
- each Open Burner
28 MJ/hr 28 MJ/hr
- each 300mm Griddle Section 21 MJ/hr 21 MJ/hr
Supply Pressure 1.13 - 3.40 kPa 2.75 - 4.50 kPa
Burner Operating Pressure (*) 0.95 kPa 2.6 kPa
Gas Connection See ‘Gas Connection’ information overleaf.
Open Burner
(each)
Griddle
(each 300mm section)
Open Burner
(each)
Griddle
(each 300mm section)
Heat Input (nett)
Nominal 6.5 kW 5.5 kW 6.5 kW 5.5 kW
Reduced 1.75 kW 1.85 kW 1.75 kW 1.95 kW
Pilot 200W 170W 200W 150W
Gas Rate (nett)
Nominal 0.69 m3/hr 0.58 m3/hr 0.51 kg/hr 0.43 kg/hr
Reduced 0.19 m3/hr 0.20 m3/hr 0.14 kg/hr 0.15 kg/hr
Pilot 0.02 m3/hr 0.02 m3/hr 0.02 kg/hr 0.01 kg/hr
Supply Pressure 20 mbar 37 mbar
Burner Operating Pressure (*) 9.5 mbar 26 mbar
Gas Connection See ‘Gas Connection’ information overleaf.

5
- All Other Markets
NOTE:
 (*) Measure Burner operating pressure at manifold test point with two burners operating at
'High Flame' setting.
 NAT, LPG & Butane Only - Operating pressure is ex-factory set and is not to be adjusted,
unless when converting between gases, if required.
 (**) TOWN GAS Only - Adjust burner operating pressure using adjustable gas regulator
supplied.
 Refer to ‘Gas Conversion and Specifications' section in this manual for further details.
Gas supply connection point is located at rear of appliance, approximately 130mm from right hand
side, 32mm from rear and 655mm from floor (55mm for bench top – B models) and is reached
from beneath appliance. (Refer to ‘Dimensions’ section). With exception of RN8200G-B and RN8203G
-B models which are 100mm from right hand side, 32mm from rear and 70mm from floor.
Connection is ½" BSP male thread (for RN8200G and RN8203G models).
Connection is ¾" BSP male thread (for all other models).
Input Rate (N.H.G.C.)
- each Open Burner
28 MJ/hr 28 MJ/hr
- each 300mm Griddle Section 21 MJ/hr 21 MJ/hr
Supply Pressure 1.13 - 3.40 kPa 0.75 - 1.50 kPa
Burner Operating Pressure (*) 0.95 kPa 0.63 kPa
Gas Connection See ‘Gas Connection’ information below.
Input Rate (N.H.G.C.)
- each Open Burner 28 MJ/hr
- each 300mm Griddle Section 21 MJ/hr
Supply Pressure 2.75 - 4.50 kPa
Burner Operating Pressure (*) 2.6 kPa
Gas Connection See ‘Gas Connection’ information below.

6
Refer to Page 9 for Cooktop options
= Rating Plate Location for
this option.
R
R

7
RN8200G Models - not available in Cabinet Base option.
R
= Rating Plate Location for
this option.
R
Refer to Page 9 for Cooktop options

8
RN8200G Models - not available in Leg Stand Base option.
Refer to Page 9 for Cooktop options
= Rating Plate Location for
this option.
R
R