j
a
j
k
l
i
p
Select bolts and spacers (if needed) according to your TV/Monitor. Attach the VESA Plate to the Monitor and tighten with a screwdriver. (Screwdriver not included).
7Manually swivel, tilt, and rotate the monitor for the best viewing angle.
6Guide the cable through the Wire Clips n1 and store the Allen Keys o in the Wire Clip n1 .
n n
o
aja
j
k
lp
i
on
Step 3.1
Select Monitor Screws
2a. Existing Grommet Hole Installation
If the existing grommet hole comes with a plastic protector, remove it to ensure a flat surface before
installing the desk mount. Position the Pole a on the mounting surface and secure using the
Support Plate j , M10 Washer k , Spring Washer l , and M10 Bolt i . Fasten the Bolt using
the provided Wrench p .
2b. Self-drilled Grommet Hole Installation
Mark the position of the hole on your mounting surface. Drill a 3/8" (10mm) diameter hole at the
marked position through the mounting surface. Position the Pole a on the mounting surface and
secure using the Support Plate j , M10 Washer k , Spring Washer l , and M10 Bolt i . Fasten
the Bolt using the provided Wrench p .
Step 3.3a
Flat Back Monitor
Step 3.3b
Curved or Recessed Back Monitor
e
e
r
s
q
4Put the assembled TV/Monitor onto the Monitor Arm d and tighten the VESA Plate e with
Nut h for stability.
h
de
M4x12 M4x30
p
jkli
aa
jkl
p
i
d
2Put the Wire Clip n1 and Monitor Arm d through the Pole a , adjust the preferred height and
tighten using Allen Key 6mm o .
d
n a
o
ø 10mm
(ø ")3/8
3
Only one screw size fits your Monitor
Step 3.2
Select Spacers ( if needed )
Hand thread screws into the
threaded inserts on the back
of your Monitor to determine
which screw (M4x12 or M4x30)
to use.
Notice: Please make sure the security nut is installed before you rotate the monitor.
h
o
n
dd
h
e
o
5Adjust the tilt angle using Allen Key 5mm n .
o
h
+90° -90°
