I
K
A2
3Put the Wire Clips k and Monitor Arms c through the Upper Pole a , adjust the preferred
height and tighten using Allen Key 5mm o .
7Manually swivel, tilt, and rotate the monitor for the best viewing angle.
6Guide the cable through the Wire Clips and store the Allen Keys o in the Wire Clips k .
Adjust the tilt angle using Allen Key 5mm n .
KIK
I
C
C
K
45°
45°
45°
45°
A2
I
Select bolts and spacers (if needed) according to your TV/Monitor. Attach the VESA Plate to the Monitor and tighten with a screwdriver. (Screwdriver not included)
Step 4.1
Select Monitor Screws
Step 4.3a
Flat Back Monitor
Step 4.3b
Curved or Recessed Back Monitor
D
F
H
G
D
M4x12 M4x30
4
Only one screw size fits your Monitor
Step 4.2
Select Spacers( if needed )
Hand thread screws into the
threaded inserts on the back
of your Monitor to determine
which screw (M4x12 orM4x30)
to use.
5Put the assembled TV/Monitor onto the Monitor Arms d and tighten the VESA Plate e with
Nut h for stability.
I
I
K
CD
E
E
D
Notice: Please make sure the security nut is installed before you rotate the monitor.E
E
Option B : Grommet Base Installation
1. Place Lower Pole a onto Grommet Base Plate m . Connect them from the bottom using M5x14
Bolt J1 and tighten with Allen Key 3mm .
I
J1
A1 B5
I
A1
B5
J1
Remove the screw and washer at the top of the M10 Hand Knob N .
If the existing grommet hole comes with a plastic protector, remove it to ensure a flat surface before
installing the desk mount.
Position the Pole A on the mounting surface and connect the hand knob N through the Support
Plate Q and the grommet hole with the Pole A . Rotate the hand knob N clockwise to fasten for
stability.
Remove the screw and washer at the top of the M10 Hand Knob N .
Mark the position of the hole on your mounting surface. Drill a 3/8"(10mm) diameter hole at the
marked position through the mounting surface.
Position the Pole A on the mounting surface and connect the hand knob N through the Support
Plate Q and the self-drilled hole with the Pole A . Rotate the hand knob N clockwise to fasten
for stability.
2a. Existing Grommet Hole Installation 2b. Self-drilled Grommet Hole Installation
A1
B3
B4
B4
B4
B4A1
A1
B3
B4 A1
A1
B4
B4
B4B3
A1
B3
B4
B4
C
ø 10mm
(ø ")3/8
