j
a
j
k
l
i
p
3Put the Wire Clip n1 and Swivel Arm d through the Pole a , adjust the preferred height and
tighten using Allen Key 6mm o . Attach the Wire Clips n1 to the Swivel Arm d .
4
6
5Put the assembled TV/Monitor onto the Swivel Arm d and tighten the VESA Plate e with
Nut h for stability.
8Guide the cable through the Wire Clips ( n1, n2 ) and store the Allen Keys o in the Wire Clip n1 .
Adjust the tilt angle using Allen Key 5mm n .
Manually swivel, tilt, and rotate the monitor for the best viewing angle.
7For safety, please do not extend the arms too far forward or backward. This may cause
instability and tip over.
n1 n1
o
n2
aja
j
k
lp
i
c
c
o
n1n2
n1
n2
n1
2a. Existing Grommet Hole Installation
If the existing grommet hole comes with a plastic protector, remove it to ensure a flat surface before
installing the desk mount. Position the Pole a on the mounting surface and secure using the
Support Plate j , M10 Washer k , Spring Washer l , and M10 Bolt i . Fasten the Bolt using
the provided Wrench p .
2b. Self-drilled Grommet Hole Installation
Mark the position of the hole on your mounting surface. Drill a 3/8"(10mm) diameter hole at the
marked position through the mounting surface. Position the Pole a on the mounting surface and
secure using the Support Plate j , M10 Washer k , Spring Washer l , and M10 Bolt i . Fasten the
Bolt using the provided Wrench p .
90°
90°
90°
90°
h
d
c
c
d
d
p
jkli
aa
jkl
p
i
a
c
o
o
o
n1
ø 10mm
(ø ")3/8
h
Note: Please make sure two arms are aligned and balanced.
n2
o
Ignore this step if monitors are level.
d
h
If one monitor is lower, remove the Nut h and turn the bolt counter-clockwise using
Allen key 3mm o to raise the monitor. Tighten the VESA Plate e with Nut h for stability
after the adjustment.
h
h
d
o
Select bolts and spacers (if needed) according to your TV/Monitor. Attach the VESA Plate to the Monitor and tighten with a screwdriver. (Screwdriver not included)
Step 4.1 Step 4.3a
Flat Back Monitor
Step 4.3b
Curved or Recessed Back Monitor
d
d
r
s
q
M4x12 M4x30
Step 4.2
Select Spacers ( if needed )
Select Monitor Screws
Only one screw size fits your Monitor
o
Hand thread screws into the
threaded inserts on the back
of your Monitor to determine
which screw (M4x12 or M4x30)
to use.
