Wali PTT008 User manual

INSTALLATION MANUAL
PTT008
Monitor Stand Riser
D
20kg/44lbs
RATED
1-844-SATTLER (18447288537)
[email protected]
www.walielectric.com

Attach the Nut E to the hole on Board C as the image shown.
Caution: Please make sure the arrow on Nut E is pointing upright towards the edge of Board C as the image shown.
Place Support Stand B on a flat surface, insert the Bolt D to the center hole on Support Stand B and tighten
with a screwdriver. (Screwdriver not included)
Caution: Please make sure the Bolt D is vertically straight at an 90° angle to the surface of Support Stand B as
the image shown.
Insert the Wood Dowel Pin F to the side hole on Support Stand B .
Supplied Parts List
2
Step 1
Step 2
Board
A (x1)
Support Stand
B (x2)
Bolt
D (x6)
Board
C (x1)
Nut
E (x6)
Wood Dowel Pin
F (x4)
Cellphone Holder
H (x1)
Sticker
I (x6)
Anti-skid Pad
G (x4)
C
C
C
B
F
D
E
E
E
B
B
B
B
B
D
F
D
D
F
Caution: Frequently assembling and disassembling may cause damage to the wood board.
Support Stand surface
DB
90° Angle
Bolt

Insert Board C to the Bolt D and Wood Dowel Pin F on Support Stand B and tighten the Nut E clockwise
to fasten for stability. (Screwdriver not included)
3
E
E
Step 3
B
B
F
B
F
D
D
C
C
C

Board surface
Place Board A on a flat surface with bottom upward, insert the Bolt D to the hole on Board A and tighten
with a screwdriver. (Screwdriver not included)
Caution: Please make sure the Bolt D is vertically straight at an 90° angle to the surface of Board A as the image shown.
Attach the Nut E to the hole on Support Stand B as the image shown.
Caution: Please make sure the arrow on the nut is pointing upright towards the hole on the Support Stand B as the image
shown.
4
D
D
D
DA
A
A
A
A
Step 4
Step 5
B
B
B
C
E
E
90° Angle
Bolt

Tighten the Nut E clockwise to fasten for stability. (Screwdriver not included)
Insert the assembled support stand to the Bolt D on Board A .
5
Step 7
Step 6
A
A
D
D
E
E

Tear off the Anti-Skid Pad G and sticker I , attach it to the designated position as the image shown.
Insert the Cellphone Holder H to the designated position on Board A .
Notice: The Cellphone Holder is removable. Push it from the back of the Board A to remove it if necessary.
Optional Step
6
Step 8
A
A
A
H
H
I
I
G
G