wallas 88DU User manual

Press the Power Button for 3 seconds until
the yellow power light will come on. When
you release the button, the yellow heating
light will appear.
COOKING
Red combustion light will light up when the
burner flame has been ignited and the
combustion has stabilised (approx. in 5 min).
Stove will be fully operational about 10 min
later.
I
P I T H E R M O C O N T R O L P A N E L
IGNITION
1) Combustion indicator
2) Temperature knob
3) Power button
4) Power indicator
5) Thermostat indicator
6) Thermostat sensor
7) Heating indicator
Turn the Temperature Knob to max. level
6 and begin cooking. Adjust it to a lower
temperature, if needed, as you would a
domestic stove.
OPERATION GUIDE
8 8 D U M a r i n e S t o v e
Please Refer to Manual for Full Operation and Maintenance Instructions at wallas.com
123
4
56
7
Press the Power Button down
for 2 seconds. Yellow heating
light will shut off immediately.
Red combustion light will
continue to flash for about 5
minutes, while the stove is
cooling down. Unit cannot be
restarted until the cool down is
completed.
The left plate is hotter and best for boiling, the right
plate is excellent for simmering at a slightly lower
temperature.
(Not in use in the 88 DU model)
(Not in use in the 88 DU model)
SHUTDOWN
I
I
I
HIGH ALTITUDE MODE
All rights reserved. Wallas-Marin reserves the right to change or improve its products and to make changes in the content of this guide
without obligation to notify any person or organization of such changes or improvements. Go to www.wallas.com for current updates and
supplemental information concerning the use of this product.
When the device is used 1500 m (4,900 ft) above sea
level, it is necessary to activate the High Altitude Mode
to adjust the combustion.
Start the stove by holding the Power
Button down for 10 seconds.
Yellow heating light will flash 3 times and
then change to a solid yellow light. High
Altitude Mode is now on and the stove has
started the ignition process.

Heating on
Combustion has begun/is running
Locked for security
The device locks itself
after two unsuccessful starts
Cooldown/Flameout
I
Heating on in High Altitude Mode
I
Overheat
I
Reminder indicating there was a fault
after fault code flashed for 5 min
30 s
www.wallas.com
Reach Out to a Wallas Professional for the Following:
Glow Failure
2 s 2 s
Combustion Air Blower Fault
2 s
Main Blower Fault
2 s
2 s
I
I
I
Low voltage (usually about 15 sec
after initiating start)
I
PANEL LIGHTS
I
UNLOCKING THE UNIT
If the unit has locked itself,
the combustion light (1) and
the heating indicator light (7)
will flash signaling there has
been a failure that should be
investigated and resolved
prior to further use. Lights
will flash for about 5 min.
1) While the lights are still
flashing, switch the main
power off from the battery
(Pull power plug, remove the
fuse, open breakers, or in-line
switch).
2) Wait for 5 sec. and switch
the main power back on.
3) Press Power Button (3) for
more than 3 seconds to shut
down the unit.
4) Restart the unit normally.
See instructional video
to unlock