Wano miniCam User manual

miniCam cabinet lock
Instruction manual

Touch panel
Low volatage indicator
Unlocking indicator light
Battery compartment Code on lock body
Knob
1
4
2
5
3
OK
LOCK OPEN
Xxxx-xxxxxxx
h
Removing battery
Battery changing
Operating
Unlocking and locking of the lock
Unlocking
1. Set your password "1234", or enter the user password "4321 + OK"
2. The castle will make a long, prolonged "dee" sound
3. When the green indicator is visible, turn the knob 90 degrees within 3
seconds to unlock the lock.
If the code is incorrect, the lock will beep three short beeps.
When the lock displays this symbol , it means low battery.
When a management password was used to open, the user's
password will be reset to the default 1234

Unlocking and locking of the lock
1 - Changing password
1. Enter the current password "1234 + OK", or enter the factory management
password "4321 + OK". The lock will then make a long "dii" sound and the
unlock indicator will flash rapidly.
2. Hold OK for at least 2 seconds, then when the unlocking indicator starts
blinking, enter the new password, press OK, and when you hear a long "dii"
beep, it means that the password has been changed
Password can contain from 4 to 15 digits. The user password cannot be the
same as the management password.
2 - Launching public mode, setting a temporary password
Public mode
1. Enter the current management password and press OK, then the lock
will make a long beep "dii" and the unlocking indicator is on
2. Hold down OK for at least 2 seconds and while the unlocking indicator
blinks, press OK.
3. Enter "4 4" and press OK, when you hear a long "dii" beep, it means
that public mode has been turned on.
Setting a one-time password in public mode
1 Press OK. Unlocking indicator will blink
 Enter a new 4-15 digit password
 Press OK, and when the lock makes a long "dii" beep, it means
that the one-time password has been entered correctly.

The flashing unlocking indicator every 3 seconds means that a
one-time password has already been assigned to the lock
3 - Turning off the public mode
1. Enter the current management password and press OK, then the lock
will make a long beep "dii" and the unlocking indicator will be on
2. Hold OK for at least 2 seconds, and when the unlocking indicator
starts blinking, press OK again.
3. Enter "4 3", then press OK, when you hear a long "dii" beep, it means
that public mode has been turned off
1. Enter the current management password and press OK, then the lock
makes a long beep "dii" and the unlocking indicator is on.
2. Hold OK for at least 2 seconds, and when unlocking indicator starts
flashing, press OK again.
3. Enter "4 2", then press OK, and when you hear a long "dii" beep, it
means that the fake PIN code function has been turned on.
4. Enter "4 1", then press OK, and when you hear a long "dii" beep, it
means that the fake PIN code function has been disabled.
While the Fake PIN function is enabled, you can enter additional
numbers before and after your real PIN and the lock will read the
matching password itself. The maximum number of digits is 16.
4 - Turning on/off fake PIN code function

Functions
1 - Decoding
1. When the password has been forgotten, the decoding number can be
obtained by providing the distributor with the lock number (located on
the casing) to be decoded. The password will be changed back to the
original management password "4321" and the user password "1234".
2. Thanks to the fake PIN code function, you can enter additional digits
before and after your real PIN code, and the lock will read the matching
password itself. The maximum number of digits is 16.
3. The auto-alarm will be activated after entering a wrong code 4 times
in a row, then the lock will be inactive for 60 seconds.
4. Low battery message (the lock will display a low battery indicator ).
5. The last entered password will be remembered after the battery
replacement.
Solving most common issues
Knob is not in the
right position
Turning on the knob into
the right position
Issue Main cause Solution
Too low voltage Battery change
The touch panel is silent, the
lock opens Buzzer is broken Changing the buzzer
When entering a password, two
"dii dii" sounds are heard and the
indicators flash twice
When entering a password, a "dii"
sound is heard while the unlocking
indicator is on but the lock does not
open

Φ.3
5020
Φ.3
Φ18
16.2
Wood
Drilling and montage
Right thickness:
•steel: 0,5~1,5mm
•wood: 16~20mm
Unit: mm

ul. Jana III Sobieskiego 80B
62-030 Luboń, Polska
tel. [phone] email:
[email protected] www.wano.pl