warequip WSP150A User manual

Manual Hydraulic Lift Trolleys
Owner’s Manual
Warequip Lift Trolleys
•WSP150A
•WSP300A
•WSP500A
•WSP800A
•
WSP350A

Page:2/5
Operation
•The operator should be positioned just behind the product handle
for best product use
•To elevate the table, the operator should push on the foot pedal
and pump regularly to achieve desired platform height
•To lower the table, gently squeeze the release lever and stop when
desired platform height is achieved
•When loading and unloading the lift trolley ensure the brake
system is locked
•When moving the lift trolley, release the brake system and ensure
the table is lowered prior to moving
•Always check the rated capacity of the lift trolley before
operation

Page:3/5
CAUTION
•Read the instruction manual carefully prior to operating
•DO NOT over load beyond rated capacity
•ALWAYSoperate truck on ground level
•Secure the balance of the load BEFORE moving
•DO NOT fully open the release lever when the trolley is loaded
•For security ALWAYS use the brake system
•KEEP foot OFF the brake pedal when lowering table
•The trolley is ONLY designed for carrying goods
•NOT allowed to carry passengers
•Equally load goods on the centre of the table before lifting or
lowering
•To ensure safety when carrying out maintence ALWAYS lock the
supports.
•DO NOT enter under this platform unless it is mechanically locked.
!

Page:4/5
•DO NOT use for climbing stairs when loaded.
•DO NOT place body parts underneath lowering table.
•ALWAYS try to operate on even ground.
•Try to slide loads onto table rather than lifting.
•Use common sense and the correct lift trolleys to reduce load-
handling injuries.
•ENSURE all operators of this unit are familiar with these,
instructions.

Page:5/5
Trouble Shooting
Trouble Cause Shooting
Table does not
raise 1. There is no oil in the
reservoir
2. Lowering Valve
(16) or Steel
Ball (30) or
Spring (31) is
not seating
Replenish the
reservoir
Table does not
remain elevated Lowering Valve (16) or Steel Ball (30) is
not sealing
Flush the Lowering
Valve or Steel Balls.
Or replace them
with a new one.
Table does not
lower U Packing (71) is worn out or Lowering Valve
(16) is not opened
Replace U packing
(8) with a new one.
Check the function
of Lowering Rod (8
or 6). Fix or replace
with a new one
Oil is leaking for
Lowering Valve O Ring (14) is worn out Replace O ring with a new one
Oil is leaking from
Cylinder Oil seal (34) or U packing (71) is worn
out
Replace the O sea or
the U packing with a
new one.