Warmrails Hyde Park User manual

OPERATION
To operate, push the switch on the end of the Towel Stand by the
cord set. It will be illuminated when on and will be dull when off.
Your Warmrail Heated Towel Stand costs less or similar to run to a
regular light bulb. It will take approximately 45 minutes for the
Heated Towel Stand to reach its operating temperature, although this
time will be shorter if towels are in place.
The Warmrails Heated Towel Stand operates with a fixed power
output. However, when operated with several layers of towels over
the heated Towel Stand, the temperature will increase. Once the
towels are removed and where the rails are exposed, the
temperature of the Heated Towel Stand will quickly drop back.
Please note: damp or wet material that has either been dyed, or is
not colorfast, can cause discoloration in the finish if that material is
draped over a Heated Towel Stand while hot. Again, it is suggested
that items are dried by using a completely protective layer of material
such as a towel underneath.
Warning – this appliance is intended only for drying textiles
washed in water. Fabrics that contain soap or detergent residue
may show what appears to be scorch marks. However this is
simply the discoloration of residue.
Warmrails does not accept responsibility for any damage,
discoloration or other damage to any item regardless of
circumstance. To reduce the possibility of damage, do not
place any items other than towels directly on the Heated Towel
Stand – always have a completely protective layer of towels
between the Heated Towel Stand and any other item.
::
bathroomsource .com Call 1-800-667-8721 anywhere in the US and Canada - www.bathroomsource.com
Warmrails at bathroom::accessories
U N L I M I T E D

ASSEMBLY
This appliance must be used in accordance with any prevailing
electrical code and relevant electrical wiring rules and regulations and in
particular those regulations that cover use of appliances and
accessories in damp situations such as bathrooms, showers, laundries
and other areas with fixed water containers.
• Your Warmrail comes complete with two long bolts and an Allen
key, which you will find in a small plastic bag. Use the bolts to
secure the base to the Heated Towel Stand.
• To assemble, first remove the long bolts and Allen key from the
plastic bag.
• Hold the Heated Towel Stand upside down (perhaps leaning it
against a chair) and position the base so that the bolt holes line up
with the two vertical bars of the Heated Towel Stand.
• You will notice that the bolts holes on the base are off-center. For
stability, the stand should be positioned so that it is attached
towards the back of the base (i.e. with the largest part of the base
to the front of the towel stand). You will also notice that the Hyde
Park is curved, and the correct way to face the unit is so that as you
look at it, the power cord comes out of the right hand side.
• Insert one bolt through each hole and use the Allen key to tighten.
• The Hyde Park Freestanding Heated Towel Stand must only be
used with the base properly fitted.
• Once the base is securely attached, the Heated Towel Stand can
be plugged into an electrical outlet (we recommend using a GFI
protected outlet). Push the on/of switch so that the light is
illuminated and your Warmrail is ready for use.
• Remember, Warmrails are so energy efficient, you can leave them
running continuously.
::
bathroomsource .com Call 1-800-667-8721 anywhere in the US and Canada - www.bathroomsource.com
Warmrails at bathroom::accessories
U N L I M I T E D

SAFETY INFORMATION
When using any electrical appliance, basic safety precautions
should always be observed.
READ THESE INSTRUCTIONS CAREFULLY
• Do NOT use this appliance for other than its intended use.
• To avoid a hazard, the Heated Towel Stand MUST NOT be
used to hold towels or any other articles that have been in
contact with oil, petroleum based products or dry cleaning
fluids.
• Use this appliance only on the voltage specified on the rating
plate, or elsewhere in the instructions.
• Regulations require that only authorized persons carry out
electrical work. For your own safety and that of others, ensure
this is done.
• Do NOT store your Heated Towel Stand while hot or still
connected to the power supply.
• Do NOT immerse the heated Towel Stand in water or any other
liquid.
• Do NOT allow the cord set to come into contact with heated
surfaces during operation.
• This product should NOT be used outdoors.
If the power supply cord for this equipment becomes damaged it
must be replaced with the special cord or assembly. Special tools
are required for the replacement of the power supply cord and
element. A qualified electrician must undertake this replacement.
WARNINGS
HIGH OPERATING TEMPERATURE:
• This towel warmer operates at high temperatures that can
cause burns.
• Do not touch surfaces of the towel warmer while the warmer is
in operation.
• Do not allow unsupervised children in the vicinity of the towel
warmer; and warn children of hot surfaces.
TO AVOID THE POSSIBILITY OF ELECTROCUTION:
• Do not immerse towel warmer in water or any other liquid.
• Do not place towel warmer in a location where it may fall into
a tub or shower, or otherwise become Immersed in water;
and if the towel warmer falls into water, immediately unplug
it. Do not reach into the water.
Do not place towel warmer in a location where it may fall into a
SPECIFICATIONS
HEIGHT WIDTH DEPTH
39” 24-1/4” 13-3/4”
CARE
The Heated Towel Stand should be wiped down from time to time
with a damp cloth.
Do not use any abrasive or corrosive cleaners.
::
bathroomsource .com Call 1-800-667-8721 anywhere in the US and Canada - www.bathroomsource.com
Warmrails at bathroom::accessories
U N L I M I T E D