
(5) Card Technology Supported
EM Card Technology
(6) Power
Reader can be powered by the access panel.
(7) Powering up Reader
1. When Reader is powered up reader will beep 1-time and blue LED will turn on.
2. When presenting a card that is not registered on the system, reader will beep 3-times with a blinking LED
of color Green.
3. When presenting a card that is registered on the system, reader will beep 1-time and Blue LED will change
to Green for 5 seconds and will go back to blue as standby.
(8) Troubleshooting
If the reader does not recognized a card or tag or does not turn on please refer to below table
Verify wiring, see (2) for proper wiring
Reader did not beep when card is presented
Verify if card technology is supported
Reader beeps but no card events showing
Verify wiegand format of the card from 24-72 bit format
Note: if any solutions above did not work please contact WatchNET Access Technical Support phone number
+1-866-843-6865 or visit our website @ www.watchnetaccess.com
All Logos & trade marks represent the registered users only. All rights reserved.
All product specifications on this brochure are subject to change without notice.
Division of WatchNET Inc.
351 Ferrier Street Unit 5
Tel: 416-410-6865
Toll Free: 1-866-843-6865
Fax: 1-866-331-3341
171 Cooper Ave. Suite 110
1-716-877-7277
Toll Free: 1-855-404-3193
Fax: 1-866-331-3341
PO Box No 126312
Office Suite 703
Oxford Towers
Business Bay, Dubai, UAE
Tel: + 971 4 2767117
RZ- 2, Ground Floor
Kapashera
Opp Kapashera Police Station
New Delhi-110037
Tel/Fax: +91 11 26816005