10
CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER
Using Mouthwash and Other Solutions
Your Waterpik®Water Flosser can be used to deliver mouthwash and
antibacterial solutions. After using any special solution, rinse unit to
prevent clogging by partially filling reservoir with warm water and running
unit with tip pointed into sink until unit is empty.
Cleaning
Never immerse unit in water. Before cleaning, unplug from the electrical
outlet. Clean the product when necessary by using a soft cloth and mild
non-abrasive cleanser to wipe exterior.
The water reservoir is removable for easy cleaning and is top rack
dishwasher safe. It is recommended that the reservoir is removed and
cleaned weekly.
Removing Hard Water Deposits
Add 1 tablespoon of white vinegar to a full reservoir of warm water. Point
the handle and tip into sink. Turn unit ON (I) and run until reservoir is
empty. Rinse by repeating with a full reservoir of clean warm water.
Battery Care and Disposal
The unit will not charge if the switch is in the ON (I) position. If you use
your Water Flosser once a day or less, it is recommended you charge it
overnight, once a week. If you use it twice a day or more, charge the unit
more frequently. Do not run the batteries down completely as this may
shorten the lifespan of the batteries and will require charging the unit for
24 hours to obtain a full charge.
If the Water Flosser is to be stored for an extended period of time (six
months or more), be sure to fully charge it prior to storage. The unit
contains a Nickel Metal Hydride battery. At the end of the battery life,
please recycle the unit at your nearest recycle center per local or state
requirements. The battery is not replaceable.
Service Maintenance
Waterpik
®
Water Flossers have no consumer-serviceable electrical items and
do not require routine service maintenance. For all your service needs go to
www.waterpik.com/intl to find your local distributor. Please do not ship product
to Waterpik International, Inc. offices, this will delay service.
Some replacement parts and accessories for the Water Flosser are also available
from your local distributor which can be found at www.waterpik.com/intl.
Refer to the serial and model numbers in all correspondence. These numbers
are located on the back of the handle and bottom of the reservoir respectively.
Still have questions? Go to www.waterpik.com/intl to find your local distributor.
20019158-FAA_WP462E1_IM_rdF2.indd 10 10/17/14 2:37 PM