WaterRower S4 Wood User manual

INTRODUCTION
We have all experienced the frustrations caused by incomprehensible
Assembly Instructions. For this reason, we have gone to added lengths
to make our instructions as clear and concise as possible. Do not be
intimidated by the detail; it is simply intended to make the assembly process
as comfortable as possible for you.
Your WaterRower comes partially dis-assembled in two boxes for protection
during shipment.
Assembling your WaterRower should take no more than half an hour, all you
require is a 5mm Allen Key which is attached to the Rear Spacer.
STEP ONE
Lay the Rails on the oor and connect the Rear Spacer using the male JCN
Nuts and the Allen Key provided.
STEP TWO
Sit the Seat between the Rails. Note the orientation of the Seat with
the indent facing the rear. It may be necessary to separate the Rails
slightly to allow the seat to sit into place.
S4 Wood Assembly Manual
STEP EIGHT
Stand the WaterRower upright. Release the Recoil Belt which is fastened to
the bracket at the base of the machine. Ensure that the Recoil Belt is passing
over all Guide Pulleys. Connect the Bungee to the Recoil Strap by hooking
the Bungee Hook through the Recoil Belt D-ring.
STEP NINE
Before lling the Tank and rowing ensure that the Recoil Belt passes smoothly
over all Rollers.
STEP TEN
Lay the WaterRower down and using the Syphon Pump provided (or a hose
if available) ll the Tank to the desired level (See Water Level section in the
Owner’s Manual) with Chlorinated Town or Municipal Water. Do not over ll
your WaterRower. Anything more than half full (or above the bottom edge of
the Paddle Shaft when the machine is standing) may risk leaking. (For exact
water amounts please refer to page 2 of your owners manual) Insert the
Stopper (it may be necessary to moisten the Stopper to assist replacement).
Congratulations, your WaterRower is now ready for use.
Rear Spacer
Male JCN Allen Key
Bungee
Recoil Belt
The black extrusions are positioned on the inside.

STEP THREE
Place the Tank Assembly between the Rails.
STEP FOUR
Place the Footboard between the Rails positioning the top two holes over
the two threaded holes in the back Tank Unit. Screw the Handle Rests into
position using the Handle Rest Bolts, do not over tighten. It may be necessary
to slightly loosen the two bolts on the Top Deck (A) to allow the Footboard
clearance.
A
STEP FIVE
Insert the JCN Nuts and JCB Bolts attaching the Tank and the Footboard to the
Rails at A & B. The Nuts should be placed on the inside and the Bolts on the
outside. Should you experience any problem with aligning the components,
loosen all the fasteners, align and re-tighten.
Handle Rest Bolt
Handle Rest
JCN Nut
JCN Bolt
AB
STEP SIX
Press the Heelrest Adjustment Button (A) and insert the Heelrest/Footpads
into the Footboard Cover Plate (B).
STEP SEVEN
Undo the Dolley Wheel Assembly and x to the Rail in the order shown and
tighten. Note - the Wheel goes on the outside of the Rail.
A
B B
A