Weishaupl Cross Backrest User manual

Scope of delivery: 2 x backrest supports, 2 x base extension (angled), 4 x screw
4 x washer, 4 x nut, 6 x wood screw
Lay the bench face down. (In order to attach the backrest supports, it should be
slightly elevated, as you need space beneath the bench). Re ove the floor glides
fro both legs on the rear side of the bench (this is the side with the wooden
strip).
Position the base extension at the leg of the bench as shown and ark the position
of the 3 holes. Re ove the base extension, place it to one side and pre-drill the
holes with a 3 drill bit. Repeat for the second bench leg.
Screw both base extensions in place using the wood screws provided.
This illustration shows how the backrest supports are attached.
Take one of the backrest supports (with the angle pointing downwards), push the
two screws through the hole fro the outside (see illustration), fit a washer on each
screw and insert the screws through the hole on the bench fra e.
Place the nuts on the screws and tighten the screws using a 6 Allen key. You
will need to counter with a 13 open-ended wrench as you do so.
Proceed in the sa e way with the second backrest support.
Place the Cross bench upright and fit the backrest.
1
2
3
4
6
7
8
9
5
ASSEMBLY INSTRUCTIONS
C R O S S B A C K R E S T

21 3
4 6
7
9
8
5