
Direction For Use
1. Place the battery correctly and close the battery cover, and set the switch to AUTO, then it goes
into light control+body induction mode ( set the switch to ON for Always mode, to OFF for
Shutdown mode )
2. When it gets dark around, once person or animal enters the sensing area, its light will be on for
about 30 seconds;
3. The sensing module of this product can be circumrotated in 60 degrees, which meets different
angles of induction.
Sensing range
It can sense darkness through photodiode, and sense the activities from human and animal
(heat) through the body infrared sensor within the range showed in the picture below to
tigger the auto-light on.
The above measurements are measured at a temperature of 25o C. The sensing range of
infrared sensors varies slightly according to temperatures.