Well EDBLN-1060-WL User manual

INSTRUCTION MANUAL
LED LIGHT WITH SWITCH
Thank you for choosing WELL. Please read carefully the following instructions and keep them within reach.
Reorder No: LEDBLN-1060-WL, LEDBLC-1060-WL

1. MAIN STRUCTURAL PARAMETERS
Voltage: 220-240V
Switch: On / Off integrated in the wide tube
Luminous flux: 1000lm
Power: 10W
Power factor: >0.8
CRI: >80
Color temperature: 4000K (LEDBLN-1060-WL), 6000K (LEDBLC-1060-WL)
Beam angle: 120⁰
Average Lifetime: 25000h
Energy efficiency class: E
Housing: PC+ALU
Size: 600x34x42mm
Protection: IP20
Working temperature: -10℃ - +40℃
Protection: IP20
Protection class: II
Certification: CE
2. ATTENTION
It is forbidden to use this product for any use other than as permitted.
The product must be installed by professionals
The power supply must be switched off before installation
3. INSTALLATION AND MAINTENANCE REQUIREMENTS
1) Turn off the power supply
2) The mounting brackets must be fixed on a firm base
3) Connect the power cords to the chassis.
4) Attach the clips to each side of the body
5) Check is any safety hazards after installation, then connect power
supply and check if the light works ok.
Waste electrical and electronic equipment are a special waste category, collection,
storage, transport, treatment and recycling are important because they can avoid
environmental pollution and are harmful to health. Submitting waste electrical and
electronic equipment to special collection centers makes the waste to be recycled
properly and protecting the environment. Do not forget! Each electric appliance that
arrives at the landfill, the field, pollutes the environment!
Importer & distributor:
SC VITACOM ELECTRONICS SRL
CIF: RO 214527
Tel. [phone]*
[email protected], www.vitacom.ro