Wenger Studio User manual

Installation Instructions
Studio®Ma eup Station
Storage Bas et Option
Storage Bas et
CONTENTS
Required Tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Fasteners and Part List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Fasteners . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Part List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Before Starting the Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Install the Storage Basket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Note: Please read and understand the Studio akeup Station Storage Basket Option Installation
Instructions before assembling the parts.
Note: Refer to the illustrations on the following pages. If you need additional information about
your Studio akeup Station, write, email, or telephone Wenger Corporation at the number
below.
©Wenger Corporation 2014 Printed in USA 02/14 Part #187A202-03
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, innesota 55060-0448
Questions? Call.....USA: 800-4WENGER (493-6437) • Worldwide: 1-507-455-4100 • www.wengercorp.com

2
FASTENERS AND PART LIST
Item Qty. Description
1 1 Storage Basket
2 4 Clip
3 4 Phillips Pan Head Sheet etal Screw, 10x3/4"
3/4"
FASTENERS
(3) Phillips Pan Head Sheet etal Screw, #10x3/4"
PART LIST
REQUIRED TOOLS
Tools required for assembly are an 8-inch long blade phillips head screwdriver. An electric screw driver
with a long extension can also be used,
Phillips Screwdriver, 8-inch

3
INSTALLATION
BEFORE STARTING THE ASSEMBLY
Before installing the Studio akeup Station Storage Basket Option, do the following.
1. Read and understand this installation instruction completely.
2. ake sure that the shipping carton contains a Storage Basket, four Clips, and four screws.
Da ger! Never remove the Cou ter to i stall the Storage Basket. Removi g the Cou ter
exposes live electrical wires. Co tact with these wires ca result i electrical shock,
serious i jury, death, or damage to property.
War i g: Always wear safety glasses whe i stalli g the Studio Makeup Statio Storage
Basket Optio . Failure to observe this precautio ca result i serious i jury.
INSTALL THE STORAGE BASKET
1. Locate the four pre-drilled pilot holes on the bottom-right or left side of the Counter.
Pilot Holes
2. Assemble the four Clips to the Storage Basket as shown below.
Clip (2)
Storage Basket (1)
3. Hold the Storage Basket (1) with the Clips (2) against the bottom of the Counter, aligning the holes
in the Clips to the four Pilot Holes.
4. Using an 8-inch Phillips screwdriver, attach the Clips to the Counter with four Pan Head Screws (3).
Cautio : Tighte the Pa Head Screws o ly e ough to be s ug. Over tighte i g ca strip the
threads i the Cou ter.
Counter Bottom Surface
Clip (2)
Storage Basket (1)
Pan Head Screw, 10x3/4" (3)
!WARNING
Do not remove the
Counter to install
the Storage Bas et.
Serious electrical
shoc or death can
result.

4
The Studio akeup Station Storage Basket Option is guaranteed free of defects in materials and
workmanship for five full years.
Our guarantee assures you of either a full refund or repair or replacement of the defective
materials or workmanship without charge, at the discretion of our Customer Service Department. Just
call a Customer Service Representative at 1-800-887-7145 and state the reason you are dissatisfied. If
a product return is necessary, your representative will issue a return authorization. This is your sole
remedy for breach of this warranty.
Should you have a question or problem with any Wenger product, don’t hesitate to call, even if the
product is past warranty. It’s important to us that all our customers be satisfied.
This is the sole warranty made by Wenger. Wenger disclaims all other warranties, including
the warranties of merchantability and fitness for a particular purpose, as well as all liability for incidental,
consequential, special, and indirect damage. Wenger liability for direct damages shall be limited to the
amount you paid for the product involved. Wenger reserves the right to make product changes without
obligation to incorporate such changes into products previously sold.
Some states do not allow the exclusion or limitation of damages or warranties, so the above may not
apply to you. This warranty gives you specific legal rights. You may also have other rights which vary
from state to state.
WARRANTY