Weslo CardioStride 3.0 User manual

Model No. 831.21901.0
Serial No.
Write the serial number in the space
above for future reference.
Serial
Decal
•Assembly
• Operation
•Maintenance
•Part List and Drawing
Sears, Roebuck and Co.
Hoffman Estates, IL 60179
TR LL User's Manual
lirn_®v_,O_W-_OI
www.iFit.com _"

TABLE OF CONTENTS
WARNING DECAL PLACEMENT ............................................................... 2
IMPORTANT PRECAUTIONS .................................................................. 3
BEFORE YOU BEGIN ........................................................................ 5
PART IDENTIFICATION CHART ................................................................ 6
ASSEMBLY ................................................................................ 7
TREADMILL OPERATION .................................................................... 11
HOW TO FOLD THE TREADMILL ............................................................. 13
TROUBLESHOOTING ...................................................................... 14
EXERCISE GUIDELINES .................................................................... 15
ORDERING REPLACEMENT PARTS ................................................... Back Cover
90-DAY FULL WARRANTY ........................................................... Back Cover
WARNING DECAL PLACEMENT
This drawing shows the location(s) of the warning decal(s). If a decal is missing or illegible, cal 1-866-
699-3756 and request a free replacement decal. Apply the decal in the location shown. Note: The
decal(s) may not be shown at actual size.
_WAR Para redudr el riesgo de lesiones sedas p&rese |
Toreduce skofse ous njury, s andon ,
en los rleles de soporte para los pies antes deJ
foot rai s before starting treadmi ; read comenzar la maqulna para cotter lea y
and understand the user's manual, all
instructions and all warnings before entienda el manual del usuario, todas Ins
'instrucciones y las advertencias antes del use
use. Keep children away, Manteng aa !os n!_os a!ejados:
WESLO is a registered trademark of ICON IP, Inc.
2

iMPORTANT PRECAUTIONS
WARNING: Toreducetheriskofseriousinjury,reada.importantprecautionsand
instructions in this manual and all warnings on your treadmill before using your treadmill. Sears
assumes no responsibility for personal injury or property damage sustained by or through the use of
this product.
1. it is the responsibility of the owner to ensure 10.
that all users of this treadmill are adequately
informed of all warnings and precautions.
=
.
Before beginning any exercise program,
consult your physician. This is especially
important for persons over age 35 or persons
with pre-existing health problems.
Use the treadmill only as described in this
manual
11.
Never allow more than one person on the
treadmill at a time.
Wear appropriate exercise clothes while
using the treadmill. Do not wear loose
clothes that could become caught in the
treadmill. Athletic support clothes are recom-
mended for both men and women. Always
wear athletic shoes. Never use the treadmill
with bare feet, wearing only stockings, or in
sandals.
.
.
The treadmill is intended for home use only.
Do not use the treadmill in any commercial,
rental, or institutional setting.
Keep the treadmill indoors, away from tools=
ture and dust. Do not put the treadmill in a
garage or covered patio, or near water.
12.
!3.
Do not operate the treadmill if the
treadmill is not working properly. (See
TROUBLESHOOTING on page 14 if the tread-
mill is not working properly.)
Always hold the handrails while using the
treadmill.
.Place the treadmill on a level surface, with
at least 8 ft. (2.4 m) of clearance behind it
and 2 ft. (0.6 m) on each side. Do not place
the treadmill on any surface that blocks air
openings. To protect the floor or carpet from
damage, place a mat under the treadmill.
14. Do not attempt to raise or lower the tread-
mill until it is properly assembled. (See
ASSEMBLY on page 7 and HOW TO FOLD
THE TREADMILL on page 13.) You must be
able to safely lift 25 Ibs. (11 kg) to raise or
lower the treadmill.
7. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
15. When folding the treadmill, make sure
that the storage latch is holding the frame
securely in the storage position.
8. Keep children under age 12 and pets away
from the treadmill at all times. 16. Do not change the incline of the treadmill by
placing objects under the treadmill.
9. The treadmill should be used only by per-
sons weighing 250 ibs. (113 kg) or less. 17. inspect and properly tighten all parts of the treadmill regularly.
3

18. Never drop or insert any object into any
opening on the treadmill. 21. Do not place hands or feet under the tread-
mill while it is in use.
19. Servicing other than the procedures in this
manual should be performed by an autho-
rized service representative only.
22. The roller guards must be 1/8 inch from
the rear roller (see the drawing on page 5).
Adjust the roller guards, if necessary.
20. Over exercising may result in serious injury
or death. If you feel faint or if you experience
pain while exercising, stop imrnediately and
cool down.
SAVE THESE iNSTRUCTiONS
4

BEFORE YOU BEGIN
Thank you for selecting the new WESLO _'CARDIO
STRIDE 3.0 treadmill. The CARDIO STRIDE 3.0
treadmill offers a selection of features designed to
make your workouts at home more effective. And
when you're not exercising, the unique treadmill can
be folded up, requiring less than half the floor space of
other treadmills.
For your benefit, read this manual carefully before
using the treadmill. If you have questions after
reading this manual, please see the back cover of this
manual. To help us assist you, note the product model
number and serial number before contacting us. The
model number and the location of the serial number
decal are shown on the front cover of this manual.
Before reading further, please familiarize yourself with
the parts that are labeled in the drawing below.
Length: 4 ft. 5 in. (135 cm)
Width: 2 ft. 3 in. (69 cm) Console
Handrail
Upright
Hood
Walking Belt Pin
Roller Guards
Rear Roller-
Rear Roller
Adjustment Screws
5

PART iDENTiFiCATiON CHART
Use the drawings below to identify small parts used for assembly. The number in parentheses below each draw-
ing is the key number of the part, from the PART LIST near the end of this manual. The number following the key
number is the quantity used for assembly. Note: If a part is not in the hardware kit, check to see if it is preat=
tached, if it is not, call 1=866=699=3756. Extra parts may be included.
M8 Nylon
Nut (2)-4
M5 x 10mm
Screw (4)-2
M8 Curved
Washer (3)-4
M8 x 15mm
Screw (7)-4
[
M8 Washer
(8)-4
M12 x 40mm Screw
(5)-2
M12 Washer
(6)-2
M4 x 12mm
Screw (9)-2
M8 x 50mm Bolt
(1)-4
6

ASSEMBLY
To watch an assembly
video, go to
http://productvideo.co/
assembly/kmart/weslo
or use your mobile
phone or smartphone to
read the QR code at the
right. A reader applica-
tion such as ShopSavvy
must be installed on your mobile phone or
smartphone.
Assembly requires two persons.
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex key
one adjustable wrench
To avoid damaging parts, do not use power tools.
.Identify the Right Upright (10), which has a single hole
in the indicated location. (Note: There is a wire inside of
the Left Upright [11].) Hold the Right Upright against the
Base (12) as shown, and orient the Right Upright so that
the two indicated holes are on the side shown.
Attach the Right Upright (10) to the Base (12) with two
M8 x 50mm Bolts (1), two M8 Curved Washers (3), and
two M8 Nylon Nuts (2) as shown. Make sure that the
curved sides of the Washers are against the Base. Do
not tighten the Nylon Nuts yet.
Attach the Left Upright (11) to the Base (12) in the
same way. Make sure that the Left Upright is oriented so
that the two indicated holes are on the side shown. Do
not tighten the Nylon Nuts yet.
3 2
3
10
12
Holes
Hole
3 2
Holes
11
7

.Raise the Left Upright (11) and the Right Upright (10) to
the position shown. 2
3. Attach the Hood (13) to the front of the Frame (14) with
two M5 x 10mm Screws (4).
.Hold the front of the Frame (14) between the Left Upright
(11) and the Right Upright (10). Align the holes near the
front of the Frame with the upper holes shown in the
Uprights. Tighten an M12 x 40mm Screw (5) with an M12
Washer (6) into each Upright and into the Frame.
4a
5
14
8

5. 5a
Align the hole on the Frame (14) with the hole in the
Right Upright (10). Insert the Pin (15) into the holes in
the Upright and the Frame. Make sure that the Pin is
fully inserted. Then, attach a Spring Clip (20) on the
end of the Pin.
Look under the Frame (14) near the Left Upright (11).
See drawing 5b. Locate the Reed Switch Clip (16)
attached to the underside of the Frame. Insert the Reed
Switch (17) into the Reed Switch Clip as shown. Next,
locate the Magnet (18) on the Flywheel (19). Turn the
Flywheel until the Magnet is aligned with the Reed
Switch. Move the Reed Switch so that there is a
1/8" (3 ram) gap between the Reed Switch and the
Magnet.
5b
1/8 in.
View from
below
15
.Hold the Handrail (27) near the Left and Right Uprights
(11, 10). Connect the Handrail Wire (21) to the Reed
Switch Wire (22). Insert the Wires down into the Left
Upright.
Attach the Handrail (27) to the Uprights (11, 10) with four
M8 x 15mm Screws (7) and four M8 Washers (8). Be
careful not to pinch the Wires (21, 22). Do not fully
tighten the Screws yet.
Place the treadmill in the storage position (see page 13).
Center the Frame (not shown) between the Uprights (11,
10).
See step 1. Tighten the four M8 Nylon Nuts (2). Then,
tighten the M8 x 15ram Screws (7). Lower the Frame
(see page 13).
827
9

7. 7
The Console (23) requires two "AAA" batteries. Alkaline
batteries are recommended. Do not use old and new bat-
teries together or alkaline, standard, and rechargeable
batteries together.
Press the indicated tab on the Battery Cover (24), and
remove the Battery Cover. Insert two batteries into the
two battery clips; make sure that the negative (-) ends
of the batteries are touching the springs in the bat=
tery clips.
.See drawing 8a. Hold the Console (23) near the
Handrail (27). Connect the wire on the Console to the
Handrail Wire (21).
Attach the Console (23) to the Handrail (27) with two M4
x 12mm Screws (9). Do not overtighten the Screws.
Make sure that the wires are not pinched.
See drawing 8b. Press the Battery Cover (24) back onto
the Console (23).
8a 23 I 8b
24
23
.Remove the paper backing from the Adhesive Clip (25).
Press the Adhesive Clip onto the left side of the Frame
(14) in the indicated location. Press the Hex Key (26) into
the Adhesive Clip.
Make sure that the walking belt is properly tightened (see
SYMPTOM 3 on page 14).
9
25 14
10. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-
pet, place a mat under the treadmill.
10