West Marine 13915137 User manual

ALWAYS: Install between exible
hoses with water owing in
designated direction on cap.
Flush before using.
Store capped in cool place. Protect
from freezing.
Filter Life/Replacement: Filter life
depends on water quality. Replace
each season or when an undesir -
able taste or odor appears.Replace
if water ow decreases signicantly.
CAUTION: Do not use where water
is microbiologically unsafe or with
water of unknown quality without
adequate disinfection before or after
the lter.This lter is designed for
outdoor use only. A regulator must
be used to limit water pressure to
60 PSI or less. See package for
additional information.
Water Filter
Bottled Water Taste
FromYour Boat’sTap!
West Marine Products,Inc.
500 Westridge Drive
Watsonville, CA95076
Made in USA
www.westmarine.com
Model 13915137
General Info ::
* Universal—Fits Cartridges:
9-3/4 inches to 10 inches tall –
2-1/2 inches to 3 inches diameter
Premium
Water Filter Kit
Instructions
Universal*
Bottled Water Taste From Your Boat’s Tap!
West Marine Products, Inc.
500 Westridge Drive, Watsonville, CA 95076
Made in USA
www.westmarine.com
Model 13915137
895112 #317
:: Always flush prior to use.
:: Protect from freezing.
:: Store in refrigerator or other cool place, out of
direct sunlight.
:: CAUTION:
Do not use where water is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after filtration.
:: Never expose to more than 100 PSI. Always use a
Water Pressure Regulator upstream of filter.
:: Use supply hoses that are suitable for drinking water.
:: To ensure the best quality water at all times and to
maximize the convenience of your experience,
it is recommended that a spare cartridge (West Marine’s
Replacement Filter Cartridge Model 13915145) be kept in a
safe place in your vessel to be used in the event of severely
adverse water conditions.

1
2
IN
OUT
Water Pressure Regulator
1. Turn off water source and press the Red
Button to relieve pressure.
2. Unscrew Filter Casing Cap (Using
provided wrench if necessary), remove
and discard used cartridge.
3. Rinse out Filter Casing and Cap. Scrub
using a non-abrasive sponge and mild
soap if necessary.
4. Carefully remove O-ring in Canister
and wipe both ring and groove clean.
Lubricate O-ring with a small amount of
food grade petroleum jelly. Seat O-ring
back in groove. Note: Ensure that O-ring
is properly seated in groove for a
water-tight seal.
5. Place new cartridge in Canister with
mesh top facing up. Replace Housing
Cap. Tighten with minimal force using
provided wrench if necessary. DO NOT
OVERTIGHTEN.
6. Before use, turn on water source and
flush filter for two minutes to remove any
carbon fines.
7. Note date of first use on the label
included with a permanent marker.
Adhere label to canister.
A ::
Apply 5 to 7 wraps of Teflon tape
(clockwise) to the male pipe threads
of the Male and Female Hose
Fittings as shown. Install the Female
Hose Fittings into the cap port
marked “IN.” Install the Male Hose
Fittings into the cap port marked
“OUT.” Tighten each fitting using a
wrench leaving one thread visible.
Leak test. If fittings leak, tighten 1/2
turn and leak test again. DO NOT
OVERTIGHTEN.
B ::
Check that Housing Cap is securely
tightened. Tighten with minimal force
using provided wrench if necessary.
DO NOT OVERTIGHTEN.
A::
Attach incoming water supply (hose) to female fitting at
“IN” port of filter.
Turn on water and flush for two minutes prior to first
connection to boat.
Turn water off.
Filter can be installed close to the boat’s water inlet or near
the water source. It is recommended to install filter as close
to the water inlet as possible. Note: To prevent breakage,
do not connect filter directly to water pressure regulator,
faucet, or boat.
Filter Washer
Inlet Assembly
Red Button
(Relieve Pressure) Outlet
Teflon®Tape
Teflon®Tape
First — Filter Cap Installation ::
Cartridge Replacement ::
Second — Hook-up Installation ::
B::
Attach supplied connector hose to boat’s water inlet. Attach
filter and water source hose.
Attach supplied connector
hose to faucet. Attach filter and
water inlet hose.
-OR-
Boat Installation
Faucet Installation
Water Filter Mounting Bracket
CARTRIDGE
Average life 3 months
Date of first use
Mesh Top