WEST UNICA-PP 962 Install guide

Fitting Instruction
962 / 963 / 964
Push Pull Handle
contentscomponents
A
B
C
D
E
F
G
H
*A,B and F are not included in xed handle.
: Lock Case 1pc
: Front Panel 1pc
:Outer Handle 1pc
: Inner Handle 1pc
: Inner Rosette 1pc
: Fixing Screw 2pcs
！(For Steel Door:M4x16 Flat Head Screw,For Wooden Door:M4x20 Flat Head Tapping Screw)
: Fixing Screw 2pcs
(M5x40 Flat Head Screw D=8)
: Fixing Screw 2pcs
(M5x35 Flat Head Screw D=8)
C
B AF
D
G
H E
963 964
Inside
Outside
Detail Drawing
Right Hand Left Hand
Downward Upward
*Shows 962.
The same goes for 963 and 964.
How to install
1.Install lock case(A) and front panel(B) with xing screw(F).
*Make sure direction of the latch.
2.Install outer handle(C) and inner rosette(E) and x it by xing screw(H).
*Make sure direction of the inner rosette.
*Make sure lock case and rosettes are installed horizontally otherwise you will not be able to
close and open the door properly.
3.Place inner handle(D) onto inner rosette(E) and x it by xing screw(G).
How to change the direction of the latch unit
1.Remove front panel and spread out the gate to pull out the latch unit. 2.Turn backward the latch unit and put it back.
Gate
Right hand
Latch unit
Pull out Put it back
Backward
Gate
Left hand

Please read this instruction well and be sure to install the product correctly. After installation,
user shall keep this instruction.
Please pay attention, not to drop and not to damage the product by xing tools and etc.
while installing.
Check the installation position before drilling the xing face.
Do not use impact drill because it may become hard to remove.
Do not remodel the product. Do not use the parts except we specify.
Do not use for a purpose other than the intended use of the product.
After installation, please conrm whether the product was correctly installed and tightly xed.
Avoid installing the product where directly wet with water.
1
2
3
4
5
6
7
8
Notes
E-mail : [email protected]om Website:https://west-lock.co.jp/en 3-18-3 Shimeno, Neyagawa-city, Osaka 572-0077 JAPAN
Do not use the product as a step and never hang on to it. These improper use causes the injury.
Make sure to install the product to the place where all the screws hold tightly.
Attention
Check the product regularly and tighten the screw again if it was loose.
Wipe with soft and dry cloth to clean products.
To remove tough stains use water with soft cloth or sponge, and then wipe enough to dry up.
1
2
Maintenance
EU-PP01190305-01/02
Cut -Out Dimensions(mm)