Westwood PT105 User manual

PT105-106
ASSEMBLY INSTRUCTIONS FOR THE WESTWOOD ROUND (PT105) AND WESTWOOD SQUARE (PT106)
*Please note that Westwood Square doesn’t have the rounded table top and seats, pictures are for
illustration purposes only.
You will have: 2 X Leg Assembly Frames (with opposite notches), 4 x Seat Assemblies, 1 x Table Top
Assembly, 28 X 3” Screws and 8 X 4” Screws.
1) Take both leg assembly frames and slot them together as shown in the picture above.

You may have to pry the frames apart slightly using a crowbar or large screwdriver to
persuade the two sections to slot together.
Fastem together with four 3” screws as indicated by the arrows.
2) Next, lift the table top in place so that the legs slot between the runners underneath the
table top. Once the table top is sitting straight and is fully pushed down onto the legs, screw
two 4” screws through the table top runners into each of the legs, as shown by the arrows.
3) Position the seat assembly onto the leg frame assembly as shown in the image above.
4) Make sure the seat is pushed right up so that the piece of wood underneath touches the
leg.

Screw Four 3” screws into the top of the seat and fix to the leg frame assembly as show by
the arrows.
Repeat this process with the remaining Three seat assemblies.
5) Fasten two 3” screws through the wooden support and into the leg of the picnic table where
the arrows indicate. Repeat for the other three seats.
Westwood Round (PT105)

Westwood Square (PT106)