Whalen Furniture Golden Oak WC-288-A User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Golden Oak Furniture Mfg., Inc. Page 1 Factory No. 16287
Task Chair (WC-288-A)
ADULT ASSEMBLY REQUIRED DUE TO THE PRESENCE OF SMALL PARTS,
SHARP POINTS, SHARP EDGES AS RECEIVED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item
to the store where it was purchased. Please call our toll-free customer service number and have
your instructions and parts list ready to provide the model name, part name or factory number:
1-866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday to Friday
Or visit our website at www.whalenfurniture.com
Or e-mail your request to [email protected]
LOT NUMBER:
DATE PURCHASED: //

Model # WC-288-A
Please call for replacement parts or assistance: 1-866-942-5362
Golden Oak Furniture Mfg., Inc. Page 2 Factory No. 16287
Parts and Hardware List
Please read completely through the instructions and verify that all parts listed are present
before beginning assembly.
A –Seat Assembly (1)
E –Telescoping Cover (1) F –Gas Lift (1)
G –5 Star Base (1) H –Caster (5) Touch-up Pen (1)
A Touch-up Pen has been provided to repair any small nicks or scratches that may occur
during assembly or shipping.

Model # WC-288-A
Please call for replacement parts or assistance: 1-866-942-5362
Golden Oak Furniture Mfg., Inc. Page 3 Factory No. 16287
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts listed.
2. To begin assembly, place 5 Star Base (G) upside down and press the Casters (H) into the
holes at the end of each leg.
3. Turn the Star Base (G) upright and insert the thick end of the Gas Lift (F) into the center hole
of Star Base. Then position the Telescoping Cover (E) over the Gas Lift (F) and rest it on the
Star Base.
4. Pick up Seat Assembly (A) and locate
center hole of bottom Mechanism over the
Gas Lift (F). Press down firmly until the seat
locks in place.
5. Before using your Chair, ensure that all the
bolts are tightened fully for safety. You can
now enjoy the comfort of your new Chair.

Model # WC-288-A
Please call for replacement parts or assistance: 1-866-942-5362
Golden Oak Furniture Mfg., Inc. Page 4 Factory No. 16287
OPERATING INSTRUCTIONS
1.To Adjust Seat Height:
While seated, lean forward and reach under the right side of the chair to find the handle. Lift the
handle and raise your body up slightly to allow the chair to rise to the desired height. To lower
the seat, lift the handle while applying more weight downward on the seat. The chair will
descend until the handle is released or the chair reaches the bottom position.
2.To Operate Tilt Lockout:
While seated, reach under the right side of the chair to find the height adjustment handle. Pull
the handle all the way out (away from the gas lift) to allow the chair to tilt backwards. To lock the
chair in the upright or vertical position, sit upright and push the handle in towards the gas lift.
3.To Adjust Tension on The Tilt:
Reach under the front center of the chair, grasp the round knob and turn it counter-clockwise to
stiffen the tilt mechanism. Turn the knob clockwise to loosen the tilt mechanism. Turn the knob
until the desired resistance is reached.

Model # WC-288-A
Please call for replacement parts or assistance: 1-866-942-5362
Golden Oak Furniture Mfg., Inc. Page 5 Factory No. 16287
INFORMATION FOR USE
1. This is one type of office chair for commercial or home use. Please use it only on
smooth, even flooring.
2. The height of the seat can be raised up and down by adjusting the handle of the
mechanism. The back can tilt after you pull the handle out.
3. Please check all bolts, screws and knobs are tight at least every 3 months or as needed.
4. If parts are missing, broken, damaged or wrong, please stop using this product until
repairs are done by a trained person.
5. Only a trained person may replace or repair seat height adjustment components.
Do not stand on this chair, do not use chair as a stepladder.
Use this product only for seating one person at one time.
Do not use this chair unless all bolts, screws and knobs are securely tightened.
Dispose of packing material properly. Do not use plastic cover as head covering. It
may cause suffocation.
Use this chair for its intended purpose only.
Use mild detergent only for cleaning.
Failure to follow these warnings could result in serious injury.
Maximum load weight on chair is 300 pounds (136 kg).
LIMITED WARRANTY
We are confident that you will be delighted with your Golden Oak Furniture purchase.
Should this product be defective in workmanship or materials or fail under normal use,
we will repair or replace it for up to one (1) year from date of purchase. Every Golden
Oak Furniture product is designed to meet your highest expectations. We guarantee that
you will immediately see the value of our fine furniture.
To make a warranty claim, contact Parts Department. Provide model number, proof of
purchase, description of the problem and obtain return authorization. At its option Golden
Oak Furniture will:
(a)Supply compatible components of current manufacture.
(b)Repair the customer’s component.
The customer must prepay freight on any components returned to the factory. Return
freight on components still in warranty will be paid by Golden Oak Furniture.
This warranty gives you specific legal rights and you may also have other rights which
vary from State to State. Customer Service: 1-866-942-5362
8:30 a.m. - 4:30 p.m. PST, Monday to Friday
THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE MAXIMUM
WEIGHTS INDICATED. USE WITH HEAVIER THAN THE MAXIMUM WEIGHTS
INDICATED MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY.

IF YOU NEED TO ORDER ANY PARTS PLEASE USE THE LIST BELOW
Task Chair (WC-288-A)
*WC-288-A-A-BR Backrest *WC-288-A-H-C Caster *WC-288-A-B-SC Seat Cushion *WC-288-A-1-3/4B Ø1/4” x 3/4” Bolt *WC-288-A-CL-LA Left Armrest *WC-288-A-2-1B Ø1/4” x 1” Bolt *WC-288-A-CR-RA Right Armrest *WC-288-A-3-1B Ø5/16” x 1” Bolt *WC-288-A-D-M Mechanism *WC-288-A-4-2B Ø1/4” x 2” Bolt *WC-288-A-E-TC Telescoping Cover *WC-288-A-5-WP Wood Plug *WC-288-A-F-GL Gas Lift *WC-288-A-6-AW Allen Wrench *WC-288-A-G-5SB 5 Star Base *WC-288-A-7-TUP Touch-up Pen
A
B
D
CL
CR
E
H
G
F1
23
4
5
67