Whirlpool LE7080XS User manual

II
AUTOMATIC
DRYERS
Electric Model
LE7080XS
and
Gas Model
LG7081XS
Iashen. Clothes Dryers. Freezen. Relrigwalor-Freezers. Ice Makers, Dishrashen, Buill-In Ovens and Sutiace Unils. Ranges. MIcrowave Ovens. Trash Compac

Parts and features
CYCLE CONTROL KNOB
\ LAUNDRY INFORMATION CENTER
TEMPERATURESELECTOR
START BUTTON
LINT SCREEN
DRYERDRUM
LOADlNG DOOR
Remove the Con-
sumer Buy Guide label
before using your
dryer. It will be easier
to remove.
Wipe out the dryer
drum with a damp
cloth to remove dust
from storing or ship-
ping.
Copy your Model and Serial Numbers here
When you need service or call with a question, have this information ready:
1. Complete Model and Serial Numbers
(from the plate located as shown). Model Number
2. Purchase date from sales slip.
Copy this information in these spaces.
Keep this book in’the Laundry Information
Center with your “Dryer Guide:’ sales slip
and warranty
Please complete and mail the Owner
Registration Card furnished with this
pmduct.
Serial Number
Purchase Date
Service Company
Telephone Number
Contents
Page Page
PARTS AND FEATURES 2 Drying Times . 8
IMPORTANT SAFETY Mixed Loads,. . 8
INSTRUCTIONS. . 3 End-of-Cycle Signal 8
OPERATING INSTRUCTIONS. 4 Lint Signal . . . . 8
Selecting a Cycle and LINT SCREEN 9
Starting Your Dryer . 4 LINT REMOVAL.. 9
Automatic Cycles. 6 CARING FOR YOUR DRYER. . . .
10
Timed Drying . . 6 Cleaning Dryer Interior . 10
DRYING TIPS . . , 7 Vacation Care 10
FLUFFAIR Setting . , 7 IF YOU NEED SERVICE OR
TUMBLE PRESS@Setting 7 ASSISTANCE . . . . . . 11
Electronic DRY-MISER@ WHIRLPOOL DRYER
Control . 7 WARRANTY . . . . . . 12
Gentle Heat 7
2 01987 Whirlpool Corporation

Additional Safety Insfrucfions and Your Responsibilffies
ALWAYS shut off the gas valve before
ALWAYS Unplug the power supply cord
leaving on vacation. or turn off electrical power before at-
NEVER use or store flammable fluids tempting to service the dryer. Shut off
(dry-cleaning solvents, gasoline, ker-
GAS VALVE if yours is a gas dryer.
osene) in or near your dryer. These sub-
You are personally responsible tar
stances give off vapors that can create
maklng sure that your dryer...
a FIREHAZARD or EXPLOSION.
l is properly maintained.
NEVER operate the dryer if...
l is properly installed and leveled in a
l it is not working right (i.e. noisy, too hot). well ventilated room* on a floor that
l it is damaged. can support the weight.
l parts are missing (i.e. door latch].
l is located in an area where the tem-
l all panels are not in place. perature is above 45°F (7.2%).
l the lint screen is loose, damaged or
l iS connected to the proper outlet and
missing. electrical supply.’
l is properly connected to fuel and ex-
l FOR YOUR SAFETY l
haust systems:
IF YOU SMELLGAS:
l is not installed against drapes or
1. OPEN WINDOWS. curtains.*
2. DON’T TOUCH ELECTRICAL SWITCHES.
l is used only for jobs normally ex-
3. EXTINGUISH ANY OPEN FLAME. petted of home clothes dryers,
4. IMMEDIATELY CALL YOUR GAS
l is not used by children or anyone un-
SUPPLIER. able to operate it properly.
*See “lnstallatlon InstructIons” tor
complete Intormatlon.
3

SUGGESTED SUGGESTED
TYPE OF LOAD CYCLE TEMPERATURE
COllONS - LINENS
EXTRA HEAVY - Bedspreads, HEAVY
mattress pads, quilts HIGH
HEAVYWEIGHT FABRICS - Towels,
jeans, corduroys, work clothes
MEDIUMWEIGHT COTTONS -
Sheets, pillowcases, cotton
underwear,diapers
LIGHTWEIGHT COllONS - Batistes,
organdies, lingerie
PERMANENT PRESS, SYNTHETICS
AND BLENDS
HEAVYWEIGHT FABRICS-Work clothes,
jackets,raiixoats .,............,._.._.
MEDIUMWEIGHT FABRICS - Shirts, play
clothes, sheets, slacks..
LIGHTWEIGHT FABRICS-Lingerie,
blouses, dresses
KNITS
HEAVYWEIGHT - Cottons, rayons,
blend&T-shirts, slacks,shirts
LIGHTWEIGHT - Synthetics (polyester,
acrylic, etc.) and blends, lingerie,
blouses, dresses
LIGHTWEIGHT AND DELICATE FABRICS
Sheer Curtains (2 or 3 panels)
Gauze, lace, etc.
AUTOMATIC PERM’T PRESS
REGULAR MED
KNITS GENTLE
LOW
PERMIT PRESS
MED
AUTOMATIC
PERMANENT
PRESS MED
LOW
AUTOMATIC MED LOW
PERMANENT KNITS GENTLE
PRESS LOW
AUTOMATIC
PERMANENT Ex LOW
PRESS
RUBBER, PLASTIC, HEAT-SENSITIVE
FABRICS
FOAM RUBBER- Pillows, bras,
stuffedtoys.........................
PLASTIC-Shower curtains,
tablecloths.........................
RUBBER-BACKED RUGS . . .
OLEFIN. POLYPROPYLENE. SHEERNYLON
FLUFF
AIR Ex LOW

I
I
1 . Select a CYCLE
Turn the Control Knob either way to
point to the cycle and setting you
want. See page 6 for information on
the cycles.
3
. Push the STARTButton
The dryer will start tumbling when you
push the STARTButton.
Ifthe STARTButton is pushed when the
Cycle Control Knob is pointing to an
OFF area, the End-of-Cycle Signal will
sound. Dryer will not start.
The Cycle Co ntrol Knob sho
not In use. If the dryer Is stopp
Control Knob to an OFF area.
luld poll
1
ed befa I
- Set
m TEMPERATURE SELECTOR
The Temperature Selector can be set
on any desired temperature or any-
where between 2 temperatures.
Tostop and restart
the drver
To stop the dryer, open the door (or
turn the Control Knob to OFF).
To restart the dryer, close the door,
select cycle, if necessary, and push
START.
It to an OFF area when the dryer is
re the cycle is finished, turn the Cycle

The automatic cycles
The automatic cycles allow you
to select the degree of dryness you
prefer for the clothes being dried.
The Cycle Control Knob will not
move until the clothes load is almost
dry, or the COOL-DOWN portion
of the cycle has been reached. After
COOL-DOWN, the knob automati-
cally moves to an OFF area and
tumbling stops.
Use
AUTOMATIC
REGULAR to
dry heavy
and medium-
weight cotton items. The load tumbles
wllhout heat during the last 5 mln-
utes. This helps make the load easier
to handle.
press, knits and other synthetic
fabrics. The load tumbles wllhout
heat during the last 10 mlnutes. This
helps keep wrinkles from setting in
and makes the load easier to
handle.
For the first few loads, set the Control
Knob to point to an * in either auto-
matic cycle. When the dryer stops, feel
the dried items.
l If items are drier than you like, use
a setting to the right of the * the next
time you dry a similar load.
l If items are not as dry as you like, use
a setting to the left of the * the next
time you dry a similar load.
Timed drying
Use the TIMED DRYING Cycle for
any load you want to dry by time. For
example: small loads, large bulky
items, items to be fluffed or dusted
with the FLUFFAIR heat setting.
l Turn the Control Knob to the number
of minutes you want-from 10 to 70.
l The last 5 minutes of this cycle are
without heat - a cool-down time. This
helps make the load easier to
handle.
6

Drying tips
The dry& does not heat when the
Control Knob is set on FLUFFAIR. This
setting can be used to fluff bedding,
plastic tablecloths, foam rubber
pillows, stuffed toys, sneakers, etc.
1. Turn the Control Knob to the number
of minutes you want in FLUFFAIR.
2. Push the STARTButton.
Electronic DRY-MISER@
Control
An electronic sensor determines
the amount of moisture in the
clothes and automatically shuts off
when the proper dryness is reached.
TUMBLE PRESS” Setting
The TUMBLE PRESSsetting removes
wrinkles from dry clothing such as
items that may have been packed
in a suitcase, closet, or items not
removed from the dryer.
1. Set Control Knob to TUMBLE PRESS.
2. Set Temperature Selector to PERM’T
PRESS/MED.
3. Push STARTButton.
The load will tumble in heated air
for 15 minutes. The heat shuts off and
the dryer continues to tumble the load
for 5 more minutes.
For best results, TUMBLE PRESSonly a
few items at a time. Put them on hang-
ers or fold them as soon as the dryer
stops.
Gentle Heat
The dryer automatically reduces
the heat settings in HEAVY HIGH and
PERMIT PRESSMED cycles. During
the last few minutes of each of
these cycles the dryer temperature
gradually reduces to a lower heat
setting. This helps prevent
overdrying.

Drying times Mixed loads
Drying times will vary depending on:
l amount of moisture in the clothes.
l type and weight of the fabric.
l size of the load.
l room temperature around the dryer
l temperature of the wash rinse water
l amount of lint in the lint screen.
l dryer temperature selection.
See your “Dryer Guide” for
more information.
End-of-cycle signal
When drying a load with different
kinds and weights of fabrics, use the
cycle suggested for the lightest fab-
rics. When the dryer stops, remove dry
items and reset the control.
The dryer sounds a signal to let you know when
the cycle is finished. The signal cannot be turned
off and is not adjustable.
The signal is helpful when you are drying per-
manent press, synthetics and other items that
should be taken out as soon as the dryer stops.
Lint signal
Clean lint screen before each load. If you
neglect to clean your lint screen, the signal will
sound. The (whistle tone] signal lets you know
the air flow is being restricted. Restricted air flow
reduces drying efficiency.
Turn off the dryer and clean the lint screen as
shown on page 9.

Lint screen
Clean the lint screen before each load. A screen blocked by lint can
increase dtvina time and may be a FIREHAZARD.
Open the lid and pull the lint screen
straight out. ROLL the lint off the screen with
your fingers.
DO NOT rinse or wash the screen.
Push the screen firmly back into place.
Lint removal
Lint can gather inside the dryer and create a FIRE HAZARD. This lint
should be removed at least every 2 to 3 years, or more often, depending
on dryer usage.
ELECTRIC DRYERS GAS DRYERS
Cleaning should be done only by a qualified person.
WARNING:
l Avoid electrical shock
hazard - unplug power
supply cord or turn off
electrical power.
l Avoid injury or damage-do not
put hands inside cabinet.
l Make sure dryer is cool.
1. Remove back panel (electric]
or lower access panel (gas).
2. Avoid damaging wires,
thermostats, funnel or igniter,
3. Remove lint from shaded area -
see art - with a soft brush or
vacuum cleaner.
4. Replace panel; reconnect and
re-level dryer. 9

Remove loose and sharp objects
from pockets and cuffs before drying -
pins, buckles, etc. Close metal
zippers.
Some pretreatment products can
damage dials, consoles and finish.
Do not use these products on or near
your dryer.
Wipe off ail spills with a damp, soft
cloth. Spills allowed to remain may
dull or damage the finish.
Never leave wet or damp laundry
in your dryer.
Sharp or heavy objects should
never be put on or in the dryer.
Check pockets for bolts, nuts etc
10
Cleaning dryer interior
WARNING: Before
cleaning interior, unplug
power supply cord or,
turn off electrical power to
avoid electrical shock hazard.
Garments which contain unstable
dyes, such as denim blue jeans or
brightly colored cotton items, may
discolor the dryer interior. If the
interior is discolored, clean with
one of the following methods to
avoid staining later load items,
Powdered laundry detergent and
very warm water
Make a paste with detergent and
very warm water. Apply paste to
a soft cloth and scrub area until
all excess dye is removed. Wipe
thoroughly with a damp cloth.
Tumble a load of rags. -OR-
Liquid spray household cleaner
Spray on stained area. Rub with
a cloth until all excess dye is
removed. Tumble a load of rags.
Vacation care
l Unplug power cord or turn off
electrical power.
l For gas dryers, close gas valve.
l Clean lint screen.