Whirlpool LA5460XPW5 User manual

AUTOMATIC
WASHER
Design 2000”
La;ze,Capacity
LA546OXP
Wave Ovens. Trash Compactors. Room Air Condltmners. Oehumldlllxs. Automatic Washers. Clothes Dryers. Freezers. AelrlgeratOr-freeze

Parts and features
LAUNDRY TEMPERATURE
CYCLE MAGIC CLEAN@
LINT FILTER
(not shown)
MODEL AND SERIAL
NUMBER PLATE
(not shown)
AGITATOR
- BASKET
TUB
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Copy your Model and Serial Numbers here
When vouneed service or call with a
question, have this information ready: Model Number
1. Complete Model and Serial Num-
bers [from plate under the lid near the
hinge). Serio, Number
2. Purchase date from sales slip
Copy this information in these spaces. Purchase Date
Keep this book in the Laundry Informa-
tion Center with your”Laundry Guide,”
sales slip and warranty. Service Company/
Phone Number
2

Your responsibilities
Read this “Use and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l is installed by a qualified installer.
l is properly installed and
leveled on a floor that can
support the weight.*
l is connected to the right kind
of outlet, electric supply, water
supply and drain.*
l is properly grounded.*
l is used only for jobs normally
expected of home automatic
washers.
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
*See the “Installation Instructions”
for complete information.
Contents
Page
PARTS AND FEATURES, 2
YOUR RESPONSIBILITIES. 3
SAFETY FIRST 3
STARTING YOUR WASHER 4
WHAT HAPPENS IN EACH
CYCLE. 6
OTHER OPERATING
INSTRUCTIONS 8
ForaRinseandSpin ,,.... 8
For a Drain and Spin 8
MAGIC CLEAN ’ Filter 8
CARING FOR YOUR WASHER 9
Winterizing 10
IF YOU NEED SERVICE OR
ASSISTANCE. 11
1. Before Calling for
Assistance 11
2. If You Need Assistance 11
3. If You Need Service 11
4. If You Have a Problem 11
01986 Whirlpool Corporation

Starting your washer
Before starting your washer:
1. Measure and add detergent.
2. Place sorted load in washer.
3. Start washer.
l The water level can be set for SMALL
[a few items1 or LARGE [a full load]. . Match the wash water temperature
to the type of fabrics and soils being
washed.
NOTE: Use the LARGE water level
for best permanent press results.
l All rinses are cold. Cold rinses
save energy and help prevent
wrinkles from setting into fabrics.
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
0
CAUTION:
in the water. Too big a load or too DO NOT
little water can cause wear or OVERLOAD WASHER.
tearing of load items.
*Approximate LARGE (17.2 gals./651 L)’
fill with load. SMALL (9.5 galsJ36.0 L)*
4

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes.
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What happens in each cycle*
Each cycle has been designed for different kinds of fabrics. Numbers On the
dial in each cycle are the minutes of WASH agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer
fills before aaitation and timina starts. After aaitation starts, the knob turns clock-
wise until it p&s to OFF and tie cycle ends.-
REGULAR HEAVY Cycle
REGULAR Cycle
A cycle for sturdily con-
structed fabrics that are
heavily soiled.
A cycle for regular loads of
fabrics that are moderately
soiled.
PERMANENT PRESS Cycle
A special cycle with the
necessary cool down rinse
which helps keep wrinkles
from setting into Permanent
Press and some synthetic
fabrics.
SHORT Cycle Use for delicate items that
need a short wash and
spin time. Wash nylon hose
or panty hose in a net
laundry bag.

NOTE: You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles, cold water is sprayed on the spinning load to help
with the rinsing.

Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.]
l Push Control Knob in.
l Turn clockwise to any* on the dial.
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For a drain and spin
Your washer can be set to drain
and spin out water.
l Push Control Knob in.
l Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l Pull Control Knob out.
l The washer will drain and spin.
MAGIC CLEAN@ lint filter
The lint filter in Your washer cleans itself. Collected
lint is drained away with the wash and rinse Water.
If Your washer drains into a tub, remove any lint
collected in the drain or strainer.

Caring for your washer
WHEN NOT WASHING, keep both
water faucets turned off. This takes
the pressure off the water inlet valve
and hoses.
AFTER WASHING, use a soft dry cloth
to wipe the outside and inside dry.
Leave the lid up until the basket is dry.
Wipe up spills right away. Spills can
dull or damage the finish.
REMOVE SHARPOBJECTS such as pins,
buckles, etc., from clothes before
washing. Close metal zippers.
SHARP OR HEAVY OBJECTS should
never be put on or in the washer.
Check pockets for bolts, nuts,
tools, etc.
SOME PRETREATMENT PRODUCTS
can damage washer and dryer dial!
consoles and finishes. Do not use
these products on or near your
washer or dryer.

Winterizing
Because some water stays in the washer, freez-
ing can cause a lot of damage. If your washer is
stored or moved during the cold weather..
1. Shut off both water
faucets. Discon-
nect and drain
water inlet hoses.
2. Put a quart of
automobile-type
antifreeze in the
basket.
To use ihe washer again.. .
I. Flush water pipes and hoses.
2. Connect hoses to the washer.
3. Turn on the water faucets.
3. Set the washer for a
DRAIN and SPIN
(see page 8). Let it
run for about 30
seconds to mix the
antifreeze and
water.
4. Run the washer
through a com-
plete cycle with
one cup of deter-
gent to clean out
the antifreeze.
10

If you need service or assistance, we
suggest you follow these four steps:
L Before calling for
assistance...
Performance problems of-ten result
from little things you can find and fix
yourself without tools of any kind.
If your washer does not fill:
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
. Are both water faucets open?
l Have you checked your home’s
main tuses or circuit breaker box?
l Are the water supply hoses kinked?
l Is the Cycle Control Knob set and
pulled out?
If your washer does not spin:
l Is the lid closed?
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
9 Have you checked your home’s
main fuses or circuit breaker box?
If your washer stops during a cycle:
l Remember, the washer pauses
briefly at different times in each cy-
cle. These pauses are normal.
Make sure the drain hose is higher
than the water level in the washer. Ii
it isn’t...
l The washer may seem to be drain-
ing during wash and rinse cycles.
l Water can siphon out. [See “lnstalla-
tion Instructions:‘)
2. If you need
assistance*. ..
Call Whirlpool COOL-LINE’ serv-
ice assistance telephone number.
Dial free from:
Continental U.S. . [phone]
Michigan . . . . . . . . [phone]
Alaska & Hawaii [phone]
and talk with one of our trained Con-
sultants. The Consultant can instruct
you in how to obtain satisfactory oper-
ation from your appliance or, if set-+
ice is necessary, recommend a
qualified service company in your
area.
3. If you need service*...
Whirloool has
v
chased TECH-CARE
mcI/-CARE Service Compa-
FRAHCH~SEDSERVICEnies, TECH-CARE
service technicians are tralned to
fulfill the product warranty and pro-
vide after-warranty service, any-
where in the United States. To locate
TECH-CARE service in your area, Call
our COOL-LINE service assistance
telephone number [see Step 2) or look
in your telephone directory Yellow
Pages under:
Call our COOL-LINE service as-
slstance telephone number (see Step
2) and talk with one of our Consultants,
or if you prefer, write to:
Mr. Robert Stanley
Division Vice President
Whirlpool Corporation
2000 US-33, North
Benton Harbor, Ml 49022
‘If you must call or write, please pro-
vide: model number, serial number,
date or purchase, and a complete
description of the problem. This infor-
mation is needed in order to better re-
spond to your request for assistance.

Whirlpool
Home A /Appliances
Making your world a little easier.
Part No. 388523
01986 Whirlpool Corporation Printed in U.S.A.
lmatlc Washers. Clothes Dryers. Freezers. Refrigerator-Freezers. Ice Makers. Olshwashers. Built-In Ovens and Surface Units. Ranges, MI