Whirlpool 8171413 User manual

Water Filter Installation Instructions
Follow these simple instructions for your lter type.
Phone:
US: 1-866-698-2538
Hours of operation:
Monday – Friday 8:00 AM – 8:00 PM EST
1. Locate the lter in the upper right hand side of the refrigerator compartment.
2. If replacing a lter, twist the used lter ¼ turn to the left. The install mark will be
lined up with the indicator mark located on the lter head.
3. Gently pull down on the lter cartridge to remove it from the lter head. Note:
there may be some water in the lter and some spilling may occur. To reduce
the amount of spillage keep the lter upright and do not tip.
4. Remove the lter from the packaging. Remove the lter cap.
5. Apply the month sticker to the lter cartridge as a reminder to replace the lter
every six months.
6. Life up the install mark located on the lter label with the indicator line that is
molded into the lter head.
7. Twist the lter cartridge ¼ turn to the right to lock it into place. The remove mark
should be lined up with the indicator line on the lter label.
8. Reduce water spurts by ushing air from the system. Run water continuously
for 4 gallons (approximately 5 minutes) through the dispenser until water runs
steady. Additional ushing may be required in some households where water is
of poor quality.
Part 8171413 & 8171414
Refrigerator Water Filter 8
TM