WHITECROFT LIGHTING Siriocci Central Manual

GENERAL INFORMATION
1. A qualified electrician, in accordance with IEE wiring regulations, should carry out
connection to mains wiring.
2. Ensure mains power is turned off during maintenance.
3. Ensure that the rated voltage and frequency requirements are compatible with the
available mains supply.
4. Cleaning of reflectors and lenses should be carried out using clean, soft and lint
free cloths and anti-static cleaning fluid.
5. Do not carry out high voltage insulation test, i.e. 500/1000v this may damage
internal components.
6. This product is class 2 insulated and so does not require an earth connection.
7. Some luminaires installed in outdoor environments may experience a build-up of
internal condensation. This is due to a difference in temperature between inside
and outside the luminaire which is quite common and acceptable under
BSEN60598.
8. Replacing the light source within this luminaire shall only be carried out by the
manufacturer, service agent or a similar qualified person.
Please note: All images shown are for illustration purposes and should be used
as a reference guide only
Whitecroft Lighting Limited
Burlington Street, Ashton-under-Lyne, Lancashire OL7 0AX
Telephone [phone] Facsimile: [phone]
Registered No. 3848973 England Registered Office: As above
PKLEAFSIRCOCENT
TECHNICAL SUPPORT
Tel: [phone]
e-mail: [email protected]
www.whitecroftlighting.com
Sirocco Central
Installation Leaflet
Jul 2016 - Rev C
SPECIFICATION
Lamp Type: LED
Lamp Colour: 4000°K
Control Gear: Fixed Output
Rating: IP66 / IK08
Weight: 14 Kg
SPECIFICATION
Body: Die cast aluminium
Diffuser: UV stabilised polycarbonate
Paint Finish: UV-stabilised coating
Power: 220-240V / 50-60Hz
Refer to website for latest lumen outputs / wattages

INSTALLATION SEQUENCE
In order to fit this luminaire, the correct sequence of assembly must be observed.
All measurements in mm unless stated otherwise
1. Remove the fitting from all of the packaging (note: handling this product may
require 2 people due to size and weight).
2. Slide spigot (supplied separately) into post and secure using screws provided
(Fig. 1).
3. Unscrew grommet of power connector and feed 2 core supply flex (Ø 9 - 12)
through (Fig. 2) (note: a terminal driver may be required to release connector
snap hooks to separate inner and outer connectors).
4. Strip Live / Neutral conductors in preparation for connection (Fig. 3).
5. Fix the Live / Neutral conductors of the 2 core supply flex to the power connector
using the securing screws (Fig. 4).
6. Fasten the inner connector to the outer connector using the click mechanism and
screw the grommet tight to secure the 2 core supply flex (Fig. 5).
7. Secure power connector to luminaire connector using the bayonet mechanism
(Fig. 6).
8. Place the luminaire head onto the spigot and secure both together using the
screws provided (Fig. 7).
Fig. 6
Power Connector
Luminaire Connector
[ Connector Assembly ]
Fig. 5
Ø 9-12
Grommet
Inner Connector
Outer Connector
[ Power Connector Assembly ]
6Nm (x4) max.
Fig. 7
Luminaire Head
Securing Screws
Post
[ Final Installaon ]
Fig. 2
Ø 9-12
Inner Connector
Outer Connector
Grommet
[ Supply Flex Inseron ]
Fig. 4
Securing Screws
[ Supply Flex Connecon ]
Fig. 3
8
30
Live / Neutral
[ Wiring Prep. ]
8Nm (x6) max.
Fig. 1
[ Spigot Assembly ]
Ø 60
120