Wi-Tek WI-CPE213-KIT User manual

300Mbps Wireless
transmission equipment
WI-CPE213-KIT
Installation Guide
CPE exclusive for elevator

Product introduction
This product is suitable for elevator monitoring. there’s a pair of
devices on the fixed end and cage end. No debugging, easy
installation, anti-interference, three network ports, flexible power
supply, adjustable power, 100 meters high stable 4K video
transmission.
Plastic expansion nail
POE combiner
Screw spike
12V DC adaptor Ribbon
Name
QTY
1
Fixed end
1
2
Cage end
1
3
12V DC adaptor
2
4
POE combiner
1
5
Ribbon
4
6
Expansion nail+screw spike
1
※If there is any damage or shortage of accessories, please contact the supplier in time.
1
Packing list
Fixed end *1
Cage end *1

Parameters
2
Antenna section
Parameters
Standard
IEEE802.11b/g/n(2T2R 300Mbps)
Working frequency
2400~2500MHz(frequencyextensionrangeis2312-2732MHz)
Antenna
Internal Antenna：gain 8dBi Horizontal 70 degrees, vertical 70 degrees.
Output power
20dBm
Rx sensitivity
-75dBm@MCS7 ， -100dBm@1Mbps
Max transfer rate
11n: 300Mbps(40M bandwidth),144Mbps(20M bandwidth)
11g: (54Mbps)
Hardware section
Voltage
24V POE or 12V DC
Interface
3x10/100M Base-TX(Cat.5/5E, RJ45)
Operating
Temperature
-30
oC
~+65
oC
Storage
temperature
-40
oC
~+85
oC
Operating humidity
5%~95%RH
Boundary
dimension
130*130*36mm
Firmware section
Fixed end
Cage end
Working mode
AP
Wireless Client
SSID
“WlAN”+“Last 6 digits of MAC address”
Match SSID
Encryption
WPA2-PSK
WPA2-PSK
Network mode
CPE
CPE
IP address
Dynamic DHCP
( default IP：192.168.1.88 )
Dynamic DHCP
( default IP：192.168.1.89 )
username
admin
admin
password
admin
admin
Note: when the device on both ends is charged, the device will
automatically establish a connection for about 1 minute.

Installation Guide on elevator
⑧ ⑨
⑥ ⑦
① ② ③ ④ ⑤
① 12V DC port
② POE port
③Reset button
④ LAN1port
⑤ LAN2port
⑥ SYS indicator
⑦ POE indicator
⑧ LAN1indicator
⑨ LAN2indicator
3

Indicator description
Indicator
Panel
status
SYS indicator
SYS
red
Starting/Fault
blue
Working normally, pair successfully
Ethernet
indicator
Ethernet
Flash
Normal,data transmitting
Blue
Normal,no data transmission
Off
No device access
Interface
indicator
LAN1
Flash
Normal,data transmitting
Blue
Normal,no data transmission
Off
No device access
Interface
indicator
LAN2
Flash
Normal,data transmitting
Blue
Normal,no data transmission
Off
No device access
Hold Reset button for 10 seconds to restore factory the device.
4