WIRE
RED: Positive-Color 1 (add 2A Fuse)
WHITE: Positive-Color 2 (add 2A Fuse)
GREEN: Positive-Steady White (add 2A Fuse)
BLACK: Negative-All Operations
BLUE: Negative-Pattern Switch
YELLOW: Synchronize Wire (Max 8 lights,
Connect yellow to yellow to sync lights
together)
PATTERN CHANGE
Apply BLUE wire to NEGATIVE
●0~2 sec. for next pattern
●2~4 sec. for previous pattern
●4~6 sec. for Factory Default
●6 sec or more for last pattern
●PH1 patterns alternate PH2
Wicked Warnings Thin-X LIN (Series 2)
Installation and Operation Instructions
IMPORTANT: Please read all of the following instructions before installing your new Thin-X LIN Series 2. WARNING: Failure to install or use this
product according to manufacturer’s recommendations may result in property damage, serious injury, and/or death to those you seek to protect!
SAFETY INFORMATION
SEE PATTERNS ON THE FOLLOWING PAGES
*Do not stare directly into these lights.
*DO NOT install this product or route any wires in the Air Bag
Deployment Zone. Refer to vehicle Owner’s Manual for
deployment zones.
*The installer must be sure that no vehicle components or other
vital parts could be damaged by the drilling process during
installation.. Install grommets into all wire passage holes.
*Inspect and operate this product regularly to confirm proper
operation.
*For this product to operate at optimum efficiency, a good
electrical connection to chassis ground must be made. The
recommended procedure requires the product ground wire to be
connected directly to the NEGATIVE (-) battery post.
If this product uses a remote device to activate or control this
product, make sure that this control is located in an area that
allows for safe operation.
*FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND
INSTRUCTIONS COULD RESULT IN DAMAGE TO THE PRODUCT
OR VEHICLE AND/OR SERIOUS INJURY TO YOU AND YOUR
PASSENGERS.
