Wido TRIKER User manual

READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT. RETAIN THEM FOR
FUTURE REFERENCE AND IF YOU PASSING THIS PRODUCT TO A THIRD PARTY, ALWAYS
MAKE SURE THIS DOCUMENTATION IS INCLUDED.
Trike Bike
User Guide
Product Code: TRIKER/TRIKEB/TRIKEBK
wido.com
Wido Limited - NG6 8TQ

SEAT
FRAME
Safety Information:
Please read this safety notice and assembly instructions before using this product. Ensure any
assembly of this product is undertaken by a responsible adult. Please make sure all parts are
working before use.
WARNING! Protective equipment should be worn. The wearing of helmets and protective equipment
for elbows, knees, wrists and as well as shoes with flat rubber soles is recommended.
This product is not to be used on roads/highways.
Children should be supervised by a responsible adult whilst using this product.
When assembly is complete, please dispose of all packaging/small parts responsibly.
Do not ride down steep inclines/slopes.
Contents:
HANDLEBAR FRONT WHEEL
REAR WHEEL FRONT BASKET
PUSHBAR REAR BASKET STEERING WIRE
REAR AXLE
STEERING TUBE
SCREW PACKAGE

How To Assemble
2. Insert the front wheel
into the frame
1. Make sure you have all
the parts
3. Add clip
5. Attach the basket to
the handlebar
4. Slide the protective
cover onto the handlebar
6. Press in the silver
spring button to attach
the handlebar to the
frame
8. Tighten up the
handlebar bolt
7. Line up the handlebars
silver button with the
hole on the frame to
securely connect
9. Basket should be
facing forward
11. Insert rear axle pole
through the plastic holes
on the back of the frame
10. Distinguish the
appearance of the bolts
12. Add black washer to
axle then add the wheel,
do this for both sides
REAR
AXLE BOLT
FRONT
AXLE BOLT

How To Assemble
14. Then tighten up the
bolt on the other side
13. Add washers and rear
axle bolts to both sides.
Clamp with a spanner
15. Add the buckle black
rear wheel cover
17. Insert the two longer
screws
16. Put the seat onto the
frame
18. Add the two bolts and
tighten on the bottom of
the seat
20. Put the back basket
onto the back of the
frame
19. Use the bottom of the
screwdriver to pierce the
two holes in the bottom
of the back basket
21. Add the two screws
23. Add the rear basket
cover
22. Add the bolts
underneath and tighten
24. Put the two white
plastic pieces into the
pushbar tube

How To Assemble
Care/Maintenance:
Simply wipe with a damp cloth to remove dirt and dust
Do not use industrial cleaners or solvents with this product as it may damage the surface/visual
appearance of the product.
26. Add the front
steering wire into the
hole on the front fork
25. Insert the steering
tube from the bottom
27. The steering wire rear
end screw is adjustable.
If the pushbar and the
handlebars are not
correct adjust this screw.
29. Add the clip into the
bottom of the pushbar
28. Add the rear end
screws into the steering
tube and tighten.
30. Put the steering
pushbar into the proper
position
32. Finished
31. Tighten the bolts
DETAIL