Wilco Offroad Hitchgate UHG1060 User manual

HITCHGATE 4/16/2007 BASIC
WILCO OFROAD Email: [e-mail]
2619 South Oak Street Phone: [phone]
Santa Ana, CA 92707
Parts List
UHG1060/1070
ITEM
UHG1060-2 / 1070-2, HARDWARE
QTY
PKG
BY
1
1/2 - 13 x 5 1/2" Hex Bolt (Gold Zinc)
1
2
1/2 - 13 Nylok Hex Nut
1
3
1/4 - 20 x 3/4" Pan head Phillips
1
4
1/4 Flat Washer
2
5
1/4 - 20 Nylok Hex Nut
1
6
Single Latch Pin w/Cable and Bracket
1
7
M14 x 1.5 x 40MM Full THD GR.8.8
3
8
M14 x 1.5 Wheel Lug Nut, (Chrome Acorn) 13/16" Hex
4
Hitchgate™ Spare
Tire Carrier
Installation Guide

HITCHGATE 4/16/2007 BASIC
9
M12 x 1.5 40MM Full THD GR.8.8
2
10
M12 x 1.5 Wheel Lug nut 3/4" Hex
3
11
Master Lock Cable, 6ft Looped
1
12
Delrin Washer (In-House Fab)
2
13
5/16" Quick Link
1
14
Polyurethane Bushing
1
15
1/2 USS Flat Washer Zinc Yellow
3
16
1/2" Flat Washer SAE Zinc Yellow
2
17
Bracket M14
1
18
Bracket M12
1
19
1/4-20x 7/8 GR8 Hex Bolt
2
20
1/4-20 Nylok Nut
2
21
1/4 GR8 Washer
4
Parts Listed Below are Assembled Before Shipping
ITEM
UHG1060-1, HARDWARE
QTY
PKG
BY
1
TireGate Sticker
2
2
3" Cap - Plug
1
3
1/2 - 13 x 3" Full Thread Hex Bolt
1
4
1/2" Flat Washer
1
5
1/2" Split Washer
1
Rubber Bumper (Pre-installed)
2
WEDGE LOCK
1
rev 070811
Hitchgate™
Installation Instructions
P/N UHG1060 and P/N UHG1070
WARNING
THE HITCHGATE MUST ONLY BE INSTALLED IN A CLASS III or CLASS V
2” HITCH ASSEMBLY.
Tow vehicles maximum trailer rating may be less then the HitchGates rating, see
vehicles owner’s guide for maximum towing and tongue weight.
By installing this product you have used 250 pounds of your current tongue load
capacity. See vehicles owners guide and tow hitch for maximum tongue weight and
reduce by 250lbs (example: Max Tongue wt 600 lbs –250 lbs = 350 lbs maximum
tongue weight available after installing this product)

HITCHGATE 4/16/2007 BASIC
1. Make sure vehicle is turned off and the emergency brake is set before
installing this product.
2. Remove hitch pin and ball mount.
3. Liberally grease the bolt and anti-rocking wedge-lock on the end of the receiver
insert. See Figure 1.
4. Insert The HitchGate wedge-lock assembly into the vehicles receiver pushing it
to its maximum depth.
5. Align the HitchGate’s hitch pin holes with the receiver’s using the hitch pin. See
Figure 1. Remove the hitch pin.
6. Tighten the anti-rocking wedge lock using a 3/4” socket and a 12” long extension
inserted through the lower 2” tube. Tighten to approx. 75 ft/lbs. (See Figure 2.)
WARNING
THE ANTI-ROCKING WEDGE LOCK IS ONLY TO CONTROL ANY ROCKING
MOTION THE HITCHGATE WOULD HAVE WHILE THE VEHICLE IS IN MOTION.
THIS IS NOT A SAFETY DEVICE. A HITCH PIN MUST BE INSTALLED SECURING
THE HITCHGATE TO THE VEHICLE’S RECEIVER AT ALL TIMES.
7. Reinsert the vehicle’s receiver hitch pin.
8. Insert the tire mount swing arm into the HitchGate frame and insert the latch pin
through the frame’s tabs and the poly-urethane bushing. (See Figure 3.)
9. Place a black plastic thrust washer on the top and the bottom of the round metal
bushing. Grease and then insert the 1/2-13x5 ½” bolt with ½ “ flat washers on the
top and bottom through the bushing and tighten snug. (See figure 3.)
10. Pull the latch pin and test the swing of the HitchGate. If it swings too easily,
tighten the pivot bolt as necessary. If it takes too much effort to make it swing,
loosen the pivot bolt as necessary. (Approx. 35 ft/lbs)
11. Attach the latch pin lanyard to the HitchGate using the supplied hardware. See
Figure 3.
Installing the upper lug bracket
12. There are 2 different upper lug brackets included in your kit. (14mm and 12 mm)
Use the larger one when possible by checking to see if it will work with your rim
or use the same size as you vehicle.
13. Install the bracket using the 2 –1/4x20 bolts just snug for now. This will allow you
to align the remaining wheel bolts when you mount the tire for the first time.

HITCHGATE 4/16/2007 BASIC
14. Mount the wheel /tire to the HitchGate tire mount using the supplied hardware
matching the bolt size to the upper mounting bracket size. Use a minimum of 3
lug bolts at all times. Full size trucks and SUV’s use 4 total lugs.
15. Snug all of the lugs and tighten the 2- 1/4x20 upper bracket bolts to 28 ft lbs.
16. Torque all of the lugs to 75 ft lbs.
WARNING
THE MAXIMUM SPARE TIRE WEIGHT ON THE HITCHGATE
MUST NOT EXCEED 150LBS.
17. Secure the wheel/tire to the HitchGate using the safety cable through the lanyard
safety loop. See Figure 3.
WARNING
THE WHEEL/TIRE MUST BE SECURED TO THE HITCHGATE WITH THE
SAFETY CABLE AT ALL TIMES.
AFTER DRIVING THE VEHICLE 25 MILES RE-TORQUE THE WHEEL LUGS TO
75 FT LBS.
CHECK THE LUGS DURING YOUR SCHEDUALED OIL CHANGES.

HITCHGATE 4/16/2007 BASIC
Figure 1. Grease wedge-lock before inserting into receiver.
Figure 2. Tighten the wedge-lock bolt to 75 ft/lbs.

HITCHGATE 4/16/2007 BASIC
Figure 3. Mounting HitchGate Swing Arm to Receiver Arm

HITCHGATE 4/16/2007 BASIC

HITCHGATE 4/16/2007 BASIC
Wilco Products Warranty and Warnings
Wilco Products provides a Limited Lifetime Warranty to the original retail purchaser who owns
the vehicle, on which the product was originally installed, for defects in workmanship and
materials.
The Limited Lifetime Warranty excludes the following Wilco Products items; latch bushings,
safety cable assembly, bolts, nuts, latch pins, tether cable, and thrust washers. These parts are
subject to wear and are not considered defective when worn. They are warranted for 90 days
from the date of purchase for defects in workmanship.
Wilco Products does not warrant any product for finish, alterations, modifications and/or
installation contrary to Wilco Products’ instructions. Alterations to the finish of the parts
including but not limited to painting, powder coating, plating and/or welding will void all
warranties. Some finish damage may occur to parts during shipping which is considered normal
and is not covered under warranty.
Wilco Products’ products are not designed nor intended to be installed on vehicles used in race
applications or for racing purposes or for similar activities. (A “RACE” is defined as any contest
between two or more vehicles, or any contest of one or more vehicles against the clock, whether
or not such contest is for a prize). This warranty does not include coverage for race vehicles, or
vehicles used for government or commercial purposes. Also excluded from this warranty are
sales outside of the United States of America.
Wilco Products makes every effort to ensure product compatibility with all vehicles listed on our
website, but due to unknown auto manufacturer's production changes and/or inconstancies by the
auto manufacturer, Wilco Products cannot be responsible for 100% compatibility, including the
fitment of tire and wheel sizes listed. Wilco Products is not responsible for damages to the
vehicle’s body or tires. Wilco Products’ obligation under this warranty is limited to the repair or
replacement, at Wilco Products’ option, of the defective product only. All costs of removal,
installation or reinstallation, freight charges, incidental or consequential damages are expressly
excluded from this warranty. Wilco Products is not responsible for damages and/or warranty of
other vehicle parts related or non-related to the installed Wilco Products product. This warranty
is expressly in lieu of all other warranties expressed or implied. This warranty shall not apply to
any product that has been subject to accident, negligence, alteration, abuse or misuse as
determined by Wilco Products.
Wilco Products components must be installed as a complete package as shown in the directions.
All warranties will become void if Wilco Products parts are combined and/or substituted with
other aftermarket products. Combination and/or substitution of other aftermarket parts may cause
premature wear and/or product failure resulting in an accident causing injury or death. Wilco
Products does not warrant products not manufactured by Wilco Products.
Installation of a Wilco Products product may void the vehicles factory warranty; it is the
consumer’s responsibility to check with their local vehicle’s dealer for warranty disposition
before the installation of the product.
It is the responsibility of the distributor and/or the retailer to review all warranties and warnings
of Wilco Products’ products with the consumer prior to purchase.
Wilco Products reserves the right to supersede, discontinue, change the design, finish, part
number and, or application of parts when deemed necessary without written notice.
Wilco Products is not responsible for misprints or typographical errors within the website or price
sheet.
2619 S. Oak St. Santa Ana, CA. 92707 Ph. [phone] Fax [phone]