Havis-Shields Telescoping Computer Base C-TCB-12 Configuration guide

C-TCB-12-INST-7-05
INSTALL INSTRUCTIONS C-TCB-12
TELESCOPING COMPUTER BASE
1992-1996 FORD BRONCO
TOOLS REQUIRED:
3/16” Allen wrench
3/8” Standard socket set
3/8” Torx set
3/8” Ratcheting wrench
Open-end wrench set
Powered drill w/ 3/8” drill bit
HARDWARE & COMPONENTS:
QTY DESCRIPTION PART #
1 Pole support assembly CM93071-12
1 Telescoping pole assembly CM93072-3
1 Side support brace CM93162
1 5/16-18 Nylock nut GSM30017
1 5/16” Flat washer GSM31006
2 ¼ x 1Hex head lag bolt GSM33060
Side support brace
Pole support
assembly
Telescoping pole
assembly
¼” x ¾”Hex
head lag bolts
5/16-18 Nylock
nut

C-TCB-12-INST-7-05
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Loosen or remove front inner and outer passenger seat bolts on vehicle.
Always!
 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit
INSTALLATION:
1. MOUNT C-TCB-12 INTO VEHICLE:
• Position Pole support assembly on top of passenger seat base front mount.
• Loosely attach inner and outer factory seat bolts.
• Attach Side support brace to pole support assembly using a 5/16-18 Nylock nut and
flat washer.
• Attach side support brace to floor of vehicle using ¼” x 1” Hex head lag bolts. A
3/16” pilot hole is required.
Note: Be sure to take caution when drilling through vehicle to avoid hitting brake or gas lines, wires,
or any other obstructions.
• Tighten factory seat bolts and 5/16” nylock nut.
• Re-attach Telescoping pole assembly to pole support assembly.
• Mount optional C-3090, computer-mounting platform, to telescoping pole assembly
using hardware and instructions provided with C-3090.