8
EN
INSTRUCTION MANUAL ·WILFA CLASSIC
BEFORE USE
ELECTRICAL CONNECTION
Check that the voltage where you shall use the unit is the same as that specied
on the unit. Details can be found on the label on the unit’s base plate.
WHEN USING THE UNIT FOR THE FIRST TIME
Please run fresh water through the unit without using a coffee lter or coffee
prior to using the unit for the rst time.
USE
• Place the Wilfa Classic on a at surface. Plug the power cord into the socket.
• Fill the water tank with fresh water to the desired amount. Place a lter
paper (1x4) in the lter holder. Place the recommended amount of coffee
into the lter.
• We recommend that you use lter ground coffee, 60 g per litre of water.
Experiment with the coffee quantities for the rst few brewing’s to nd the
amount which you think is optimal.
• We also recommend that you use a Wilfa scale for best results.
• Attach the lter holder to the bracket and turn it clockwise for locked
position.
• We recommend the following ratios of water and coffee (please note that
different grinds and coffee types will inuence these ratios somewhat):
1,25 l - 75g
1 l - 60g
0,75 l - 45g
0,5 l - 30g
• Press the start button to start the brewing process.
• When the brewing process is complete, the unit will switch over to the keep
warm state. The start button will remain lit up. After 40 minutes the coffee
maker will automatically be switched off. If you want to switch off the coffee
maker before 40 minutes (with light in start button) just press the start button
once and the coffee maker will be switched off.
TIPS
• Rinse the coffee lter in water to remove any unwanted taste prior to
brewing.
• Always use fresh coffee. You will obtain the best results if the coffee you use
is freshly ground. Grounded coffee loose many of its aromas just after a few
minutes and by grinding the coffee yourself just before you brew, you keep
all the good aromas for the best coffee taste.
