Winegard TR-6018 Manual

†† For Winegard models: TR6100, TR6018, CarryOut MP1 1
Setup Instructions for
Winegard Manual Tuning
Satellite Antenna††
&DISH Receiver
Setup | Installation | Receiver Activation
Software Version L551RGND-N

†† For Winegard models: TR6100, TR6018, CarryOut MP1 2
Setup of Winegard Manual Tuning Satellite Antenna†† &DISH Receiver
Setup | Installation | Receiver Activation
Software Version L551RGND-N
INSTRUCTIONS ESTIMATED SETUP TIME
STEP #1
DO NOT hook up your Winegard manual tuning satellite antenna at this time.
STEP #2
Power up TV and ViP®211k Receiver.
STEP #3
Select ‘Menu’ from your remote. From the Main Menu page, select ‘611’ on your remote control number pad.
STEP #4
Point Dish –Connect your Winegard manual tuning satellite antenna to your receiver.
STEP #5
Point Dish –Enter your zip code using your DISH remote in the ‘Zip Code’ field.
–Then, select your dish system by scrolling on
your DISH remote in the ‘Dish System’ field.
–This will give you the coordinates to position
your Winegard manual tuning satellite
antenna; follow those coordinates.
–The green status bar at the bottom of this
screen will indicate which satellite (110, 119,
129) you have found. If it does not
automatically enter the satellite information
in the ‘Satellite’ field, enter it manually with
your DISH remote.
–Select ‘Check Switch’

†† For Winegard models: TR6100, TR6018, CarryOut MP1 3
STEP #6 20 MINUTES
Installation Summary –Select ‘Test’
STEP #7
Installation Summary –Select ‘Done’
If using TR6100, you should see all three satellites at this step (110, 119, 129)
NOTE: If you see an X in the place of the satellite information (110, 119, 129) at this step, select ‘Done’ and
reposition your satellite antenna, following the instructions starting at Step #5.
STEP #8
Select ‘Done’ on your DISH remote, and then select ‘Cancel’ from the Main Menu three (3) times.

†† For Winegard models: TR6100, TR6018, CarryOut MP1 4
STEP #8 5 MINUTES
535 Popup: Acquiring Signal
STEP #9 10 MINUTES
Installation Wizard: Connect Receiver to Ethernet or Phone –Select ‘Continue’
NOTE: Connecting Ethernet or Phone is not required; it will automatically sequence through if you choose not to connect.
STEP #10 10 MINUTES
Installation Wizard: Activate Receiver
First-Time Activation of DISH ViP®211k Receiver
To activate, call the applicable number listed below.
New DISH Customers: 1.800.970.9623
Existing DISH Customers: 1.888.854.9535