Winegard TRAV'LER DIRECTV SK-SWM3 User manual

Automatic Multi-Satellite TV Antenna
For help, email [e-mail]
or call 1-800-288-8094
Wrap Cable Replacement
Instruction Manual
for models SK-SWM3 and SK-1000
Trav’ler
2452532

Removing the Turret
Before you begin make sure the antenna is in the stowed position, and the
interface box is unplugged from power.
Disconnect the coax cable(s) from the base and
sheath cable from the vertical ports.
Remove the four screws from the cable cover.
Remove the cable cover.
Loosen and unclip the power coupler from the
internal power cable.
Unthread and remove the power/control cable
retaining nut. Do not lose the retaining nut.
Remove nuts securing coax ports at base and top
of turret, then push the ports into the turret.
1
3
3
4
2

Remove the 9 screws holding the turret to the
transition plate
Flip turret over, remove gasket and moisture and
barrier.
Remove p-Clip holding wrap cable in place.
Removing Electronics
Disconnect cable connections from electronics
module.
Using provided nut driver remove the 4 screws
holding the electronics module in place
5
6
7
1
2

Remove wrap cable from rubber grommet on
electronics module.
Removing Elevation Motor Assembly
Remove the 4 screws holding the elevation
motor in place.
Remove the elevation motor and disconnect
cable from motor.
Replacing Wrap Cable
Remove 2 screws securing wrap cable to turret,
and remove wrap cable.
Install new wrap cable in place of the original,
and secure using the 2 screws
3
2
1
2
1

Reinstalling Elevation Motor and Electronics
Reconnect cable to elevation motor and reinstall.
Secure in place using the 4 screws.
Feed wrap cable through rubber grommet on
electronics
Using provided nut driver and 4 screws secure
electronics back in place.
Attach cables to electronics in the following order
from left to right.
• 12-pin connector
• 8-pin connector
• Male coax on wrap cable
• Male coax on included mini cable
1
2
3
4

Securing Wrap Cable
Seat coax ports in the following order from top to
bottom.
• Black/Red
• Blue/Blue
• Blue/Black
Secure Ports in place using the nuts removed in
“Removing the Turret” section step 4.
Secure p-clip to turret.
Seat coax ports at base in the following order from
left to right.
• Blue/Black
• Blue/Blue
• Blue/Red
Secure ports in place using the nuts removed in
“Removing the Turret” section step 4.
Reinstalling the Turret
Ensure gasket and moisture barrier are aligned
properly on transition plate.
Place turret back on transition plate and secure
using the 9 screws
1
3
1
2
2

Slide data cable connection through hole in base
and secure in place using the retaining nut from
“Removing the Turret” section step 3.
Reconnect data cable and reinstall cable cover,
secure cover with 4 screws.
Reconnect coax cables at base and sheath
cable to vertical ports. Sheath cable should be
connected in order shown in picture.
With the wrap cable replaced you can now plug the interface box into power
and operate the antenna as desired.
3
4
5

Printed in U.S.A. © 2023 Winegard Company Rev 11-23 2452532
Winegard is a registered trademark of Winegard Company.
Winegard Company 2736 Mt. Pleasant St. |Burlington, IA 52601
For help, email [e-mail] or
call 1-800-288-8094
SCAN FOR
MORE PRODUCT
INFORMATION
WARRANTY
OR CALL
800-288-8094