AN-304 PIR Motion Sensor User Manual
5
3. Operation
Turn on: Press and hold the Turn on/off button on the back of the device for
about 2 seconds. Release the button as the green light on.
Join network: After starting up, the LED enters a 60-second slow flashing state
and the red light flashes slowly, indicating that the device doesn’t join the
network successfully and when the light changes from red to green, indicating
that the device joins network successfully.
Note: After the device is switched on, the LED indicator will only have a
60-second slow flashing state, this state will be cancelled after 60 seconds
regardless of whether the device has successfully joined the network or not.
Auto-detecting mode: After starting up, it will enter into auto-detecting mode
within the first 5 minutes. If it detects a motion within the detecting area, the
device will send out a detection signal and the red light will flash.
Working mode: After starting up and 5 minutes later, it will enter into normal
working mode. There is a 5-minute interval between 2 alarm signals detected.
After 5 minutes, if it detects motion, the device will send out alarm signals again.
Dismantle alarm: In normal working mode, when the device dismantled, it will
send out illegal disassembly signal with the red light flashing.
Heartbeat: The device will send heartbeat signals to the cloud platform every 8
hours to report its working status.
Turn off: Long press the Turn on/off button on the back of the device for 1.5s,
LED light will turn green and then red, and then releasing the button, the device
will be turned off and stop working.
