110113 PRODUCT MANUAL EBC-Z5xx 10
Jumper Reference
CompactFlash Master 1-2
CompactFlash Slave (default) 2-3
□
□
□
J41
3
2
1
J41 - CompactFlash
NOTE: Jumper Part# SAMTEC 2SN-BK-G is applicable to all jumpers. These are available in a ten piece kit from
WinSystems (Part# KIT-JMP-G-200).
J12 - Ethernet Conguration
Ethernet Port 1
Non-Volatile Memory Protection
(Install Jumper to Disable Protection) 1-2
Auxiliary Power Present
(Remove Jumper when powered in ATX Mode -
Default Installed)
3-4
Ethernet Port 2
Non-Volatile Memory Protection
(Install Jumper to Disable Protection) 5-6
Ethernet Port 2 Present
(If Ethernet Port 2 is not installed, remove jumper) 7-8
J12
1 3 5 7
2 4 6 8
□ □ □ □
□ □ □ □
J31 - COM3, J32 - COM4, J36 - COM1, J42 - COM2
RS-422/RS-485 Termination and Biasing Resistors
TX (100): Places a 100Ω Resistor across the TX+/TX- pair 3-4
RX (100): Places a 100Ω Resistor across the RX+/RX- pair 7-8
TX/RX(300):
Places a 100Ω Resistor from +5V to TX/RX+ 1-2
Places a 100Ω Resistor between TX/RX+ and TX/RX- 3-4
Places a 100Ω Resistor from Ground to TX/RX- 5-6
□ □
□ □
□ □
□ □
2
4
6
8
J31
1
3
5
7
□ □
□ □
□ □
□ □
2
4
6
8
J32
1
3
5
7
□ □
□ □
□ □
□ □
2
4
6
8
J36
1
3
5
7
□ □
□ □
□ □
□ □
2
4
6
8
J42
1
3
5
7
J33 - EEPROM
EEPROM Enable
EEPROM Enabled (default) 1-2
EEPROM Disabled 3-4
□ □
□ □
4
2
J33
3
1
