Wisco Industries 520 User manual

MODEL 520
HEATING ELEMENT REPLACEMENT
0022824SK
FS140140 REV: ORIG
7-15-2020 Page 1 of 4
DESCRIPTION
This document illustrates how to replace the Heang Element for model 520.
TOOLS NEEDED
• #2 Phillips Screwdriver
• Small, Flathead Screwdriver
• Pliers
PARTS INCLUDED
• (1) 0022841 - Regulang Thermostat

MODEL 520
HEATING ELEMENT REPLACEMENT
0022824SK
FS140140 REV: ORIG
7-15-2020 Page 2 of 4
Remove oven door by opening the
door all the way, liing up to sepa-
rate from latches, and pull out
Remove support rack from the
inside of the oven by liing the
rack up, and pulling it out from
the latches that hold it in place.
(For beer assistance on how the
latches are laid out, see the photo
Remove (3) panel screws from inside
of the oven. Once completed, ip the
unit over.

MODEL 520
HEATING ELEMENT REPLACEMENT
0022824SK
FS140140 REV: ORIG
7-15-2020 Page 3 of 4
Remove (20) screws from the boom
of the oven & (4) screws from the
back of the oven (located by the ar-
rows). Once completed, remove the
boom of the oven.
Remove (2) screws that aach the vent to
the oven; remove the vent.
Remove (2) screws connected to
the base of the heang element.

MODEL 520
HEATING ELEMENT REPLACEMENT
0022824SK
FS140140 REV: ORIG
7-15-2020 Page 4 of 4
Remove (2) nuts and (3) screws holding the heang element in place; remove the heang element.
Using the new element, complete all steps in reverse order and you have successfully replaced your units heang element. Your unit
is now ready for operaon.