Wittkopp PrimorSignal plus User manual

Installation instructions
PrimorSignal plus
1 General instructions
• Please read the operating instructions carefully, before activating the lock.
1.1 Liability notes
• The mounting of the signal box has to be carried out according to the installation instruction.
• We point out that this installation instruction is part of the VdS-certification and non-compliance leads to the loss of this
certification.
• The signal box has to be protected against external attacks.
• Do not insert any lubricants or other substances into the signal box .
2 PrimorSignal plus installation
The control unit PrimorSignal plus connects the lock system with a superior control e.g. a danger alert system, burglar alarm
system etc.
Notes:
• The lock system is power supplied by the burglar alarm system. (nominal voltage 12 VDC - permitted range: 9-15 VDC,
400mA), clamp 20 (+) und 21 (-) )
• Note: Remove the battery from th input unit.
• In cases of power cuts a battery can be used to power supply the input units RO and FS for emergency openings. For the
input unit FL the emergency opening is possible via the emergency power supply contacts.
© Carl Wittkopp GmbH - Errors and omissions excepted
Installation instructions no. 9999-131-0
Fig. 1: Dimensions control unit PrimorSignal plus

2
Installation instructions PrimorSignal plus
Rel. 1.0
3 Configuration plan
The output cable must be connected to “BAT” connector placed on the lock (Primor 3000 - conncetion 2).