Wizard Electronics ON-VD5000II User manual

1
OPERATION MANUAL
Mini Digital Video Recorder and
Mini IR CCD Camera
ROHS CE FCC
Operating Instructions
Before operating the unit, Please read this manual
thoroughly, and retain it for future reference .

2
Warning:
Be sure to read the following before using the recorder and the
mini camera.
Attention
-Whenever connect or separate the camera form the DVR ,
please power off DVR
-Whenever plug in or pull out the sd from the DVR ,
Please power off DVR
-To Prevent fire or shock hazard , do not expose the unit to rain or
moisture.
-
To avoid the potential risk of data loss always copy data to a disk
-Do not detach or rebuild and repair by yourself.
-Do not knock the product strongly.
-Please contact seller for any repairing matters.
LCD screen and mini camera
Be careful when placing the camera near a window or outdoors .
Exposing the LCD screen or the lens of camera to direct sunlight
for ling period may cause malfunctions.

3
Features:
DVR
1.Portable body camera
2.Zoran Taiwan Chip
3.960*320 2.7 Inch LCD
4.Video resolution
1080P@30fps,720P@60fps,480P@30pfs ( optional)
5.Photo resolution: 16M,12M,5M,3M
6.Motion Detection , Video Recording(Loop
Recording) ,Tacking Photo(Continuous Shooting),
Pre-Recording (5s)
7.Power saving , automatic sleep
8.2.4g wireless remote control , 1-5 meters
9.Built-in in 128 MB, support max 32 Gb SD card (1080P:
10 hours)
10.Removable 2200mah Lithium battery , 4 hours life time ,
35 hours standby, 4 hours charging
11.AV , video out put to a big screen

4
Camera
1.Button mini hidden camera
2.Sensor 1/3 Inch 3Mpixels image sensor
3.WDR Picture and Video quality
4.3.7MM 65 degree viewing
5.0.1Lux Low Illumination

5
Identifying the part of the mini DVR
1. USB Data 2. Earphone/AV-Out
3. Screen Unlock 4. Quick-Record
5. DC 6. SD Card Slot
7. Rec. 8. Picture
9. Up 10. Enter/Replay
11. Down 12. Power on /off , Menu
13. HDMI Video-in 14. Battery Lock

6
1.Connect 2.Up
3.Picture 4.Rec.
5.Replay/Stop/Ok 6.Menu
7.Down

7
Identifying the part of the camera
1.Power on 2.Power Off
3.Mic 4.Rec
5.Take Photo

8
One touch record（audio&video）
4 types video record modes :
1.DVR power on and switch the auto record key to
left side , video record start . switch to right side, video stop
recording and save ( when you switch to left side , when
you power on , dvr will auto video record )
2.DVR power on and click Rec. Button, video record
start , click again , video stop recording and save .（do not
work when the DVR lock )
3.DVR power on and click remote record button , video
start record, click again , video stop and save .
4.Use the camera record button
LED indicator :
Vibration indicator :
Mode Led indicator
Recording video Red-flashing
Photo tacking Red-flashing one time
Full charged Indicator light off
No signal Blue-off
Mode Vibration indicator
DVR power on / off Vibration 2 s
Video record start Vibration 1 time
Video record stop Vibration 3 times

9
Motion Detection/ Pre-recod 5s
Dvr power on ,open the Dvr menu , select
Pre-Capture ( Motion Detection), After setting , press
“ ”record key return to standby mode,DVR will change
to motion detection mode(pre-record 5s) , shows on
the bottom-left of the screen at the same time.(Note:
motion detection need set again , when the dvr restart)
DVR setting menu :
1.Photo resolution : 16M,12M,5M,3M
2.Video resolution:1080P30,720P60,720P30,480P30
3.Continue shot : ON , OFF
4.Pre-Capture: Motion Detect , Manual, OFF
5.Over write : ON , OFF
6.Vibration motor : ON , OFF
Photo taking Vibration 1 time
No signal Vibration 2 times

10
7.Language: English ,简体中文，繁體中文，한국의，русс
кий，日本の
8.Auto LCD off: 45Sec, 30Sec,15Sec,OFF
9.Auto sleep : 3Min, 2Min,1Min,Off
10.Auto power off : 15Min, 10Min, 05Min, OFF
11.Frequency: 50Hz ,60Hz
12.TV standard: PAL , NTSC, LCD
13.2.4G Remoter: Set, Cancel
14.Default: OK , Cancel
15.Format: OK , Cancel
16.Date/Time: 2013/05/20
+08 00:21:24
17.User number: Set , Off （support numbers and letters)
18.Memory infos: movie,photo,free space, total space:
19.Version: Ver:1.2.15

11
Playback :
Dvr power on ,click the playback , replay photos
and video , click menu button , can delete the files or
lock the files ( when you set Over write, the lock files will be
save )
Palying back moving images on TV screen :
When the dvr power on , connect the dvr with TV screen
via AV output cable.
Dvr power on ,open the Dvr menu , select TV
standard ( choose PAL / NTSC).
Playing back oving images on PC :
1.Take out the sd card , connect it with the computer via
the card reader.
2.Conect the Dvr with the camera via the USB cable , them
DVR Power on .


Accessories
DVR
Camera

13
Error Clear Operation
Error Reason Method
Power on light: off Lack Power Power charging
Camera Indicate light: off Machine/line
control/camera :Connect loose
Do connect the line and
interface before power on
again
Vibration unit continuous
vibrating Lack Power & EMS Memory full
Please connect charger
for charging power or
change EMS Memory