Wolf-Guard MD-01 User manual

MD-01
Pet-Immune PIR Motion Detector
EN
USER MANUAL
www.wolf-guard.com

1×PIR Pet-Immune Motion Detector
1×Bracket
1×User Manual
Introduction
Box Content
MD-01 motion detector adopts delicate and modern design with
intelligente analysis algorithm which effectively identify
interference signal from body movement signals. This motion
detector will not trigger the alarm when your pets (under
10kg) move inside your home, even if your alarm system is
armed. With low-battery status LED indication.
1

Product Overview
Battery cover
Indi cator
PIR Le ns
Bracket slot
2

LJCELL
Lithium Bat ter y
CR123A 3V
1300mAh
PCB Layout
Infr ared se nsor
Tamp er swit ch
LED in dicat or
Tamper switch: When the alarm system is armed, the tamper
switch will trigger the alarm if the case is opened.
Infrared sensor: Detects the infrared rays released by human body
motion. Do not touch the surface. Keep the surface clean.
LED indicator: (Green indicator on) sensor is tiggeed and
send alarm signal. (Red indicator on) battery is in low power
status, please change it.
3

Step 1: Fix the bracket on the wall with screws and attach the
detector to the bracket. Adjust the bracket to change the
Installation
Step 3: No obstacle or floating object is allowed (such as flower,
grass, clothes and curtain that will be easily be wafted by wind)
in the detecing area.
detection distance and angle. It is recommended to mount
the detector 1.8-2.5m from the ground.
Step 2: Avoid installing the motion detector directly toward
windows or near heat sources, such as heat extraction units,
aircondition, micro-wave oven, refrigerator etc. Also try to
avoid placing two motion detectors in the opposite of each other
and don’
t place them in each other’
s detection range.
4

5
After successful coding, install the PIR detector. Please pay
attention to the installation height and detecting area. Make
sure the switch is powered on after adjusting angle and height.
2
After installation, please walking in the range of detecting,
if the siren rings out, the alarm is working.
3
Set the alarm panel to coding status (please refer to the alarm
panel manual), then trigger the detector by hand (or walking in
front of the detector) to make it send wireless signal to the
alarm panel for coding.
1
Test and Coding
110°
0m 3 m 6m 9 m
2m
Detection Range
Top view Side view
0m

6
Model Number:
MD-01
Backup Battery:
3V 1300mAh
Static Current:
< 28uA
Alarm Current:
< 17mA
Detection Range:
12m / 110°
Pet Immunity:
< 10kgs
Specifications
Transmitting Distance:
≤ 80meter (in open air)
Radio Frequency:
315MHz / 433MHz
Housing Material:
ABS Plastic
Operation Condition:
Temperature
Relative Humidity:
≤ 90% (Non-condensing)
Dimensions (L×W×H):
116 x 60 x 37 mm
° °
-0C ~ +35C