Wolo SEE-WAY 6050 User manual

Your choice of a Wolo rechargeable work light is the perfect choice for use at home, boating, camping, roadside
assistance and etc. Wolo manufactures this product with the finest materials. Each light is tested to meet our high
standards before it is packaged, to assure a perfect working light. Our quality workmanship and components
are Wolo’s assurance of a product that will give years of dependable service. If you need help using your new
Wolo work light, our technicians are available to
answer your questions, Monday thru Friday, from
9 AM to 4 PM EST at 1-888-550-4676.
IMPORTANT: Read this instruction sheet before
using the work light to ensure safe operation
/ storage. The Lithium-Ion battery will last
hundreds of safe charge / discharge cycles.
Always follow the simple guidelines below and
use the same caution and care that would be
given to an electronic or electrical device.
TO OPERATE WORK LIGHT:
1. Press and release the On/Off button to
turn on.
2. Press and release the Mode button to
select from four (4) different modes:
HIGH BEAM • LOW BEAM • FLASHING
S-O-S and FAST FLASH.
3. Press and release the On/Off button to
turn off.
4. When the battery is fully charged, you
should have approximately 4.5 hours
of work time when using the high beam
and 9.0 hours when using low beam.
TO CHARGE BATTERY:
IMPORTANT: Use only the 110-volt AC charger
or 12-volt power wire with cigarette lighter plug
provided to charge the work light’s battery. (The
battery may need to be fully charged before first
use). There are four (4) LED lights on the front panel which shows the user when it is necessary to recharge
the light’s battery. When the battery is fully charged the four (4) LEDs are illuminated. The user can check the
battery’s charge condition by simply turning on the light.
5. The male plug connected to the charger’s wire, is inserted into the socket located in the backside bottom
of the light.
6. Connect the charger to 110-volt AC power source or cigarette lighter plug to 12-volts DC (vehicle’s
accessory power outlet).
7. The 110-volt AC charger and the 12-volt charger plug have a LED indicator, while charging it will illuminate
red and will change to green when the battery is fully charged. Allow approximately 4-5 hours charge
time if the battery is fully discharged and the work light does not turn on.
NOTE: When using the 110-volt AC charger, you may feel it gets slightly warm to the touch; that is normal.
OPERATING INSTRUCTIONS FOR
WOLO SEE-WAYTM MODEL 6050
15-WATT LED WORKLIGHT
Magnet
Base
Fold-away
Handle
On / Off
Battery Level
Indicator
Mode:
• High Beam
• Low Beam
• Flashes S-O-S
• Fast Flash
12-volt
power charger
Male
Plug
LED
Charge
Indicator
LED
Charge
Indicator
Male
Plug
110-volt
AC charger

STORING THE WORK LIGHT:
DO NOT STORE THE WORK LIGHT WITH THE BATTERY FULLY CHARGED FOR LONGER THAN 3 MONTHS.
When storing the work light away for long periods of time without use, drain the battery down by turning on
the work light for about 5 minutes, before storing. Failure to follow this procedure can result in damage to the
battery during long-term storage.
CARE FOR BATTERY:
The work light’s Lithium-Ion battery will last you for hundreds of safe charge / discharge cycles. The work light
is designed to turn off automatically to prevent over draining of the battery. There is an automatic cut off circuit
that will stop charging the battery when it reaches a full charge (7.4 volts) and the charge indicator will illuminate
green.
MAGNET BASE:
Built into the light’s base are five (5) strong protected magnets that will secure the light to any ferrous
metal surface.
HANDLE:
The light has a convenient handle that allows the user to carry or hang the light. When the handle is not needed,
it folds away.
DISCLAIMER
The WOLO SEE-WAY work light can generate extremely bright concentrated beams of light! Never look directly
at LEDs while the light is turned on. Never shine the light directly into the eyes of others. Permanent eye
damage can result from misuse. The rechargeable Lithium-Ion battery used is just like the ones found in laptop
computers, cell phones, and cordless power tools. Special precautions should always be taken when charging,
discharging, and storing the work light.
• Use only the 110-volt AC charger or 12-volt power wire with cigarette lighter plug provided, to charge
7.4v Li-Ion battery.
• NEVER LEAVE BATTERY CONNECTED TO CHARGER UNATTENDED.
• NEVER ALLOW BATTERY TO BECOME OVERHEATED. Never allow the BATTERY to heat to a temperature
over 158°F (70°C). Li-Ion Battery can vent electrolyte or explode.
• NEVER SUBMERGE BATTERY IN WATER OR EXPOSE TO WET CONDITIONS.
• NEVER DISASSEMBLE BATTERY. If a replacement battery is needed, only use an exact
replacement, Wolo part number 6000B available from Wolo by calling: 888-550-4676 Monday-Friday
9:00 AM – 4:00 PM EST.
• ALWAYS KEEP WORK LIGHT AND ITS BATTERY AWAY FROM CHILDREN.
• ALWAYS KEEP WORK LIGHT AND ITS BATTERY AWAY FROM OPEN FLAME.
ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF THREE (3)
MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY
SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHERARISING OUT OF BREACH OF WARRANTY OR OTHERWISE.
To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase.
Provide with the return a brief description of the problem with a daytime telephone number. Also, include with the return a
check or money order in the amount of $10.00 to cover return shipping.
Mail to:
Wolo Manufacturing Corp.
Attn: Warranty Service
One Saxwood Street, Deer Park, NY 11729
E-mail: [email protected]
© 2020-2022 Wolo Mfg. Corp All Rights Reserved.
WARRANTY
Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase,
that this product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will
either repair or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase together
with proof of purchase as described below. Wolo reserves the right to inspect any defect prior to settling any warranty claim
by repair or replacement. This warranty is limited as above provided and Wolo will not be responsible for fire or other casualty
or accident, due to neglect, abuse, abnormal use, modifications, faulty installation of this product, or natural causes.