
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCCID:XXXXXXXX
FCC statement
This equipment has been tested and found to comply with the limits for a Class B
digitaldevice, pursuant to Part 15 of the FCC Rules.These limits are designed to
provide reasonable protection against harmfulinterference in a residential installation.
This equipment generates, uses and canradiate radio frequency energy and, if not
installed and used in accordance withthe instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a
particularinstallation.
·If this equipment does cause harmful interference to radio or televisionreception,
which can be determined by turning the equipment off and on, theuser is encouraged
to try to correct the interference by one or more of thefollowing measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment andreceiver.
—Connect the equipment into an outlet on a circuitdifferent from that to whichthe
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure warning
·The equipment complies with FCC RF exposure limits set forth for anuncontrolled
environment.
The equipment must not be co-located or operating in conjunction with anyother
antenna or transmitter.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subjectto the following two conditions: (1) this device may not cause interference, and (2) this devicemust accept any interference, including interference that may cause undesired operation of thedevice. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillageradioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.